Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-17T20:17:20.988Z Has data issue: false hasContentIssue false

Microstructure and Mechanical Properties of a Single Crystal NiAl Alloy with Zr or HF Rich G-Phase Precipitates.

Published online by Cambridge University Press:  26 February 2011

I. E. Locci
Affiliation:
NASA Lewis Research Center, MS 105–1, Cleveland, Ohio 44135
R. D. Noebe
Affiliation:
NASA Lewis Research Center, MS 105–1, Cleveland, Ohio 44135
R. R. Bowman
Affiliation:
NASA Lewis Research Center, MS 105–1, Cleveland, Ohio 44135
R. V. Miner
Affiliation:
NASA Lewis Research Center, MS 105–1, Cleveland, Ohio 44135
M. V. Nathal
Affiliation:
NASA Lewis Research Center, MS 105–1, Cleveland, Ohio 44135
R. Darolia
Affiliation:
GE Aircraft Engines, Cincinnati, Ohio 45215
Get access

Abstract

The possibility of producing NiAl reinforced with the G-phase (Ni16X6Si7), where X is Zr or Hf, has been investigated. The microstructures of these NiAl alloys have been characterized in the as-cast and annealed conditions. The G-phases are present as fine cuboidal precipitates (10 to 40 nm) and have lattice parameters almost four times that of NiAl. They are coherent with the matrix and fairly resistant to coarsening during annealing heat treatments. Segregation and non-uniform precipitate distribution observed in as-cast materials were eliminated by homogenization at temperatures near 1600 K. Slow cooling from these temperatures resulted in large plate shaped precipitates, denuded zones, and a loss of coherency in some of the large particles. Faster cooling produced a homogeneous fine distribution of cuboidal G-phase particles (≤10 nm) in the matrix. Preliminary mechanical properties for the Zr-doped alloy are presented and compared to binary single crystal NiAl. The presence of these precipitates appears to have an important strengthening effect at temperatures≥1000 K compared to binary NiAl single crystals.

Type
Research Article
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Polvani, R.S., Tzeng, W.S. and Strutt, P.R., Met. Trans. 7A, 33 (1976).Google Scholar
2. Whittenberger, J.D., Westfall, L.J. and Nathal, M.V., Scripta Metall. 23, 2127 (1989).Google Scholar
3. Doychak, J.K., Smialek, J.L., and Barrett, C.A., in Oxid. High Temp Int, edited by Grobstein, T. and Doychak, J. (The Minerals, Metals & Materials Society, Warrendale, PA 1988) pp. 4155.Google Scholar
4. Raj, S.V., Noebe, R.D. and Bowman, R.R., Scripta Met. 23, 2049 (1989).CrossRefGoogle Scholar
5. Gladyshevskii, E.I. et al. , Kristallografiya 6, 769 (1961).Google Scholar
6. Locci, I.E. and Noebe, R.D., in Proc. 47th Annual Mtg. EMSA, edited by Bailey, G. W., (San Francisco Press, San Francisco, 1989), p.308.Google Scholar
7. Noebe, R.D., Bowman, R.R., Locci, I.E. and Raj, S.V., 2d HITEMP Review 1989, NASA CP-10039, p.48 (1989).Google Scholar
8. Spiegel, F. X., Bardos, D.J., and Beck, P.A., Trans. Met. Soc., AIME, 227, 575 (1963).Google Scholar
9. Gladyshesvkii, E. I. et al. , Dopov. Akad. Nauk. Ukr. RSR, 4, 481, (1962)Google Scholar
10. Zeller, M.V., Noebe, R.D. and Locci, I.E., in Proc. 3rd HITEMP Review 1990, NASA CP-10051, p.21 (1990).Google Scholar