Hostname: page-component-6bf8c574d5-qdpjg Total loading time: 0 Render date: 2025-02-20T14:38:33.706Z Has data issue: false hasContentIssue false
  • English
  • Français

Mechanical Properties of TiAl and (TiAl+Ti3 Al) Alloys Produced by Mechanical Alloying

Published online by Cambridge University Press:  16 February 2011

S. Ochiai ,
M. Kobayashi  and
K. Michimura
S. Ochiai
Affiliation:
Nagaoka University of Technology, Nagaoka, 940–21 Japan
M. Kobayashi
Affiliation:
Nagaoka University of Technology, Nagaoka, 940–21 Japan
K. Michimura
Affiliation:
Nagaoka University of Technology, Nagaoka, 940–21 Japan
Get access

Abstract

Two representative titanium aluminides containing 48 and 52 at. pct Al were produced by a mechanical alloying (MA) process for the purpose of attaining fine microstructures. For the MA apparatus, an attritor mill and a conventional ball mill were both used and the results compared. Mechanically alloyed powders were consolidated by hot pressing. In addition to morphological changes in the powders during MA, microstructures and mechanical properties of the consolidated products were studied. In particular, the MA alloy with 48 at. pct Al comprised of both TiAl and Ti 33Al phases showed a high strain rate sensitivity exponent, above 0.3. This suggests a possibility of developing superplastic deformation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 196: Symposium T – Superplasticity in Metals, Ceramics, and Intermetallics , 1990 , 201
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Lipsitt, H.A. in High-Temperature Ordered Intermetallic Alloys, edited by koch, C.C., Liu, C.T., and Stoloff, N.S. (Mater. Res. Soc. Proc. Pittsburgh, PA 1985) p. 3 5 1.[2] J.B. McAndrew and H.D. Kessler J. Metals, 8, 1348 (1956).Google Scholar
[3] Schulson, E.M., Res.Mech. Letters, 1, 111 (1981).Google Scholar
[4] Davis, R.M., J. Metals, 39, 60 (1987).Google Scholar
[5] Khadkikar, P.S., Vedula, K., and Shabel, B.S., Met.Trans., 18A, 425(1987).Google Scholar
[6] Benjamin, J.S. and Volin, T.S., Met. Trans., 5, 1929 (1974).Google Scholar
[7] Murray, J.L. in Binary Alloy Phase Diagram, edited by Massalski, T.B. (ASM.Metals Park, OH, 1,1986), p.173.Google Scholar
[8] Huang, S.C. and Siemers, P.A., Met.Trans. 20A, 1899 (1989).Google Scholar
[9] Tsujimoto, T., Hashimoto, K.,Nobuki, M., and Suga, Hiroo, Trans. Japan Inst. Metals, 27, 183 (1986).Google Scholar