Hostname: page-component-78c5997874-dh8gc Total loading time: 0 Render date: 2024-11-05T09:53:08.064Z Has data issue: false hasContentIssue false

Magnetoresisnve La-Sr-Mn-O Powders and Films by Daas Technique

Published online by Cambridge University Press:  15 February 2011

S. Yang
Affiliation:
Department of Chemistry, Northern Illinois University, DeKalb, IL 60115
C.-T. Lin
Affiliation:
Department of Chemistry, Northern Illinois University, DeKalb, IL 60115
K. Rogacki
Affiliation:
Department of Physics, Northern Illinois University, DeKalb, IL 60115
B. M. Dabrowski
Affiliation:
Department of Physics, Northern Illinois University, DeKalb, IL 60115
P. M. Adams
Affiliation:
The Aerospace Corporation, P.O. Box 92957, Los Angeles, CA 90009
D. M. Speckman
Affiliation:
The Aerospace Corporation, P.O. Box 92957, Los Angeles, CA 90009
Get access

Abstract

Magnetic perovskites of the general form La1-xSrxMnO3 have successfully been synthesized using deposition by aqueous acetate solution (DAAS). This novel technique, which has the potential for depositing large area min films with high throughput and low cost, involves the preparation of an aqueous metal acetate precursor solution, drying the solution to generate a glassy gel, consolidating the gel, and then firing it for short periods of time (<2hrs) to produce crystalline lanthanum strontium manganate (LSMO). The DAAS method has been used to prepare both powders and thin films of LSMO. Powder samples of La0.83Sr0.17MnO3 annealed for 100 minutes at 1200°C were high purity, single phase, and exhibited excellent electrical and magnetic characteristics. Thin films of La0.7Sr0.17MnO3 deposited onto both sapphire and strontium titanate substrates and annealed at 900°C were also found to be crystalline, and substrate choice was found to influence thin film crystal structure. These films exhibited sharp metal-insulator transitions, and in the case of LSMO films on strontium titanate, magnetoresistance was observed at the unusually high temperature of ∼360K.

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Rao, C.N. R., Cheetham, A.K., and Mahesh, R., Chem. Mater. 8, 2421 (1996)Google Scholar
2. Van Roosmalen, J.A.M. and Cordfunke, E.H.P., J. Solid State Chem. 110, 106 (1994)Google Scholar
3. Chakraborty, A., Sujatha Devi, P., and Maiti, H.S., Materials Letters 20, 63 (1994)Google Scholar
4. Urushibara, A., Moritomo, Y., Arima, T., Asamitsu, A., Kido, G., Tokura, Y., Phys. Rev. B 51, 14103 (1995)Google Scholar
5. Otoshi, S., Sasaki, H., Ohnishi, H., Hase, M., Ishimaru, K., Ippommatsu, M., Higuchi, T., Miyayama, M., and Yanagida, H., J. Electrochem. Soc. 138, 1519 (1991)Google Scholar
6. Gharbage, B., Henault, M., Pagnier, T., and Hammou, A., Mater. Res. Bull. 26, 1001 (1991);Google Scholar
Hashimoto, T., Ishizawa, N., Mizutani, N., and Kato, M., J. Cryst. Growth 84, 207 (1987)Google Scholar