Hostname: page-component-6bf8c574d5-gr6zb Total loading time: 0 Render date: 2025-02-18T06:39:11.770Z Has data issue: false hasContentIssue false
  • English
  • Français

The Influence of W Filament Alloying on the Electronic Properties of Hwcvd Deposited a-Si:H Films

Published online by Cambridge University Press:  17 March 2011

A. H. Mahan ,
A. Mason ,
B. P. Nelson  and
A. C. Gallagher
A. H. Mahan
Affiliation:
National Renewable Energy Laboratory, Golden, CO 80401
A. Mason
Affiliation:
National Renewable Energy Laboratory, Golden, CO 80401
B. P. Nelson
Affiliation:
National Renewable Energy Laboratory, Golden, CO 80401
A. C. Gallagher
Affiliation:
Joint Institute for Laboratory Astrophysics, Univ. Colo. and NIST, Boulder, CO 80302
Get access

Abstract

In depositing a-Si:H by HWCVD using W filaments, one issue common to this technique is that of filament lifetime. When using undiluted silane as the source gas, a buildup of silicon at the colder ends of the filament is routinely observed (thickening), and it is here that filament breakage usually occurs. Less well understood is the effect of filament alloy formation on a-Si:H electronic properties. In this work we combine ambipolar diffusion length (SSPG) measurements on consecutively deposited a-Si:H films with SEM surface topography and sputter (SP) Auger depth profiling of the filament Si/(W+Si) composition to track film electronic properties as a function of the Si buildup on short filaments entirely exposed to the growing film surface. We find that with increasing exposure time of the filament to silane, appreciable Si exists everywhere along the filament length, even in the non-thickened central regions. We discuss the effect of this alloying on the film deposition rate and electronic properties, and suggest that the nature of the filament surface must be carefully considered when optimizing a- Si:H film electronic properties. Finally, we discuss possible ways to minimize this alloying by post deposition treatments, which include different filament ‘run’ temperatures.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 609: Symposium A – Amorphous & Heterogeneous Silicon Thin Films – 2000 , 2000 , A6.6
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.see Mahan, A. H., Gedvilas, L. and Webb, J. D., J. Appl. Phys. 87, 1650 (2000) and references therein.Google Scholar
2. Mahan, A. H., Reedy, R. C. Jr, Iwaniczko, E., Wang, Q., Nelson, B. P., Xu, Y., Gallagher, A. C., Branz, H. M., Crandall, R. S., Yang, J., and Guha, S., MRS Symp. Proc. 507, 119, (1998).Google Scholar
3. Mahan, A. H., Vanecek, M., Poruba, A., Vorlicek, V., Crandall, R. S., and Williamson, D. L., MRS Symp. Proc. 507, 825, (1998).Google Scholar
4. Matsumura, H., Extended Abstract of Int'l Pre-Workshop on CAT-CVD (HW-CVD) Process, Sept. 29, 1999, Ishikawa, Japan, p. 1.Google Scholar
5. Matsumura, H., J. Appl. Phys. 65, 4396, (1989).Google Scholar
6. Doyle, J., Robertson, R., Lin, G. H., He, M. Z., and Gallagher, A. C., J. Appl. Phys. 64, 3215, (1988).Google Scholar
7. Conde, J. P., Brogueira, P., and Chu, V., Phil. Mag. B 76, 299, (1997).Google Scholar
8. Nelson, B. P., Crandall, R. S., Iwaniczko, E., Mahan, A. H., Wang, Q., Xu, Y., and Gao, W., MRS Symp. Proc. 557, 97, (1999). In Figure 1 the ‘corners’ of the 6-way cross as well as the shutter help provide additional isolation between the alloyed end regions of the filament and direct ‘line of sight access’ to the substrate.Google Scholar
9.As the SSPG values decrease with decreasing film thickness, we normalized our SSPG values for films deposited with an ‘alloyed’ filament against our best (identically prepared) films deposited with ‘virgin’ filaments.Google Scholar
10. Nelson, B. P. and Iwaniczko, E., unpublished.Google Scholar
11. Mahan, A. H., Carapella, J., Nelson, B. P., Crandall, R. S., and Balberg, I., J. Appl. Phys. 69, 6728, (1991).Google Scholar
12. Molenbroek, E., Mahan, A. H. and Gallagher, A. C., J. Appl. Phys. 82, 1909, (1997).Google Scholar