Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-19T06:35:13.059Z Has data issue: false hasContentIssue false
  • English
  • Français

The Impact of Deposition Parameters on the Optical and Compositional Properties of Er Doped SRSO Thin Films Deposited by ECR-PECVD

Published online by Cambridge University Press:  01 February 2011

Michael Flynn ,
Jacek Wojcik ,
Subhash Gujrathi ,
Edward Irving  and
Peter Mascher
Michael Flynn
Affiliation:
Centre for Electrophotonic Materials and Devices, Department of Engineering Physics, McMaster University, Hamilton, Canada
Jacek Wojcik
Affiliation:
Centre for Electrophotonic Materials and Devices, Department of Engineering Physics, McMaster University, Hamilton, Canada
Subhash Gujrathi
Affiliation:
Groupe de recherche en physique et technologie des couches minces, Lab. René -J.-A. Lévesque, Département de Physique, Université de Montréal, Montréal, Canada
Edward Irving
Affiliation:
Centre for Electrophotonic Materials and Devices, Department of Engineering Physics, McMaster University, Hamilton, Canada
Peter Mascher
Affiliation:
Centre for Electrophotonic Materials and Devices, Department of Engineering Physics, McMaster University, Hamilton, Canada
Get access

Abstract

Silicon rich silicon oxide films were fabricated by electron cyclotron resonance plasma enhanced chemical vapor deposition (ECR-PECVD). The films were doped in situ using an organometallic precursor. Optical measurements show that the refractive indices of the films are determined by the silane to oxygen flow rate ratio used during the depositions. The erbium content as measured by elastic recoil detection (ERD) is also strongly dependent on the oxygen flow rate, with more erbium being incorporated in the more highly oxygenated films. The erbium content was also found to vary inversely with plasma power, which did not have a significant effect on the silicon to oxygen ratio. This allows the erbium and excess silicon levels of the films to be controlled independently.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 866 , 2005 , V5.7/FF5.7
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1) Ossicini, S., Pavesi, L. and Priolo, F., Light Emitting Silicon for Microphotonics, Springer, 2003.Google Scholar
2) Walters, R. J., Bourianoff, G.I. and Atwater, H.A., Nature Materials, 4, 143 (2005).Google Scholar
3) Kuritsyn, D., Kozanecki, A., Przybylińska, H. and Jantsch, W., Phys. Stat. Sol. (c), 1, 229 (2004).Google Scholar
4) Han, H.-S., Seo, S.-Y. and Shin, J.H., Appl. Phys. Lett. 79, 4568 (2001).Google Scholar
5) Andry, P.S., Varhue, W.J., Ladipo, F., Ahmed, K., Adams, E., Lavoie, M., Klein, P.B., Hengehold, R. and Hunter, J., J. Appl. Phys., 80, 551 (1996).Google Scholar
6) Boudreau, M., Boumerzoug, M., Mascher, P., and Jessop, P., Applied Physics Letters, 63, 3014 (1993).Google Scholar
7) Griffiths, D.J., Introduction to Electrodynamics, Prentice Hall, p. 404 (1999).Google Scholar
8) Gujrathi, S.C., Rooda, S., D'Arcy, J.G., Pflueger, Randall J., Desjardians, P., Petrov, I., Greene, J.E., Nuc. Inst. and Meth. B 136-138 (1998).Google Scholar
9) Flynn, M., Irving, E., Roschuk, T., Wojcik, J. and Mascher, P., Compositional and Optical Characterization of SiOx Films Deposited by ECR-PECVD for Photonic Applications, 1st International Conference on Group IV Photonics, Hong Kong (2004).Google Scholar
10) Sassella, A., Borghesi, A., Corni, F., Monelli, A., Ottaviani, G., Tonini, R., Pivac, B., Bacchetta, M. and Zanotti, L., J. Vac. Sci. Technol. A, 15, 377 (1997).Google Scholar
11) Chu, V., Conde, J.P., Jarego, J., Brogueira, P., Rodriguez, J., Barradas, N. and Soares, J.C., J. Appl. Phys., 78, 3164 (1995).Google Scholar
12) Barbour, J.C. and Doyle, B.L. in Handbook of Modern Ion Beam Materials Analysis, Tesmer, J.R. and Natasi, M. eds., Materials Research Society (1995).Google Scholar
13) Roschuk, T., Wojcik, J. and Mascher, P., Proceedings of the SVC 47th Annual Technical Conference, 362 (2004).Google Scholar