Hostname: page-component-586b7cd67f-rcrh6 Total loading time: 0 Render date: 2024-11-29T07:42:43.680Z Has data issue: false hasContentIssue false
  • English
  • Français

High Rates and Very Low Temperature Fabrication of Polycrystalline Silicon From Fluorinated Source GAS and Their Transport Properties

Published online by Cambridge University Press:  15 February 2011

T. Kamiya ,
K. Nakahata ,
K. Ro ,
C. M. Fortmann  and
I. Shimizu
T. Kamiya
Affiliation:
The Graduate School, Tokyo Institute of Technology, 4259 Nagatsuta, Midori-ku, Yokohama, Japan
K. Nakahata
Affiliation:
The Graduate School, Tokyo Institute of Technology, 4259 Nagatsuta, Midori-ku, Yokohama, Japan
K. Ro
Affiliation:
The Graduate School, Tokyo Institute of Technology, 4259 Nagatsuta, Midori-ku, Yokohama, Japan
C. M. Fortmann
Affiliation:
The Graduate School, Tokyo Institute of Technology, 4259 Nagatsuta, Midori-ku, Yokohama, Japan
I. Shimizu
Affiliation:
The Graduate School, Tokyo Institute of Technology, 4259 Nagatsuta, Midori-ku, Yokohama, Japan
Get access

Abstract

Low temperature (50-300°C) growth of polycrystalline silicon (poly-Si) by very high frequency (100MHz) glow-discharge plasma enhanced CVD using SiF4 and H2mixtures was studied. The poly-Si microstructure was strongly affected by the SiF4/H2 gas flow ratio. For example, either (220) or (400) preferentially oriented films were prepared by appropriate SiF4/H2 ratio selection. The addition of small SiH4 flows to the SiF4/H2 mixtures could be used to increase the growth rate while the SiF4/H2 continued to control the film structures such as preferential orientation. Highly crystalline films were grown at a growth rate of 0.52nm/s using SiF4/H2/SiH4 flow rates of 30/90/2.Osccm (respectively). However, at higher SiH4 flows amorphous films were deposited. Under the small SiF4/H2 ratio condition, highly crystallized poly-Si was grown at temperatures as low as 50°C. N/i/Pt Schottky diode solar cells were prepared using these poly-Si for both the n- and the i-layers. These solar cells exhibited good performance; for example, open circuit voltages over 0.32V. N-i-p solar cell results are very promising with 6.2% of conversion efficiency being achieved in the initial trials.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 557: Symposium A – Amorphous and Heterogeneous Silicon Thin Films—Fundamentals to Devices—1999 , 1999 , 513
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Ishihara, S., He, D., Akasaka, T., Araki, Y. and Shimizu, I., Mat. Res. Soc. Symp. Proc., 297, 79 (1993).Google Scholar
2. He, D., Okada, N. and Shimizu, I., Solar Energy Materials and Solar Cells 34, 271 (1994).Google Scholar
3. Nakata, M. and Shimizu, I., Mat. Res. Soc. Symp. Proc. 283, 591 (1993).Google Scholar
4. Kamiya, T., Nakahata, K., Miida, A., Fortmann, C. M. and Shimizu, I.: Thin Solid Films 337, 18 (1999).Google Scholar
5. Nishimiya, T., Kondo, M. and Matsuda, A., Mat. Res. Soc. Symp. Proc., 467, 397 (1997).Google Scholar
6. Seto, J. Y.W., J. Appl. Phys., 46, 5247 (1975).Google Scholar