Hostname: page-component-586b7cd67f-t7fkt Total loading time: 0 Render date: 2024-11-25T17:58:55.855Z Has data issue: false hasContentIssue false
  • English
  • Français

Growth of polycrystalline silicon at low temperature on hydrogenated macrocrystalline silicon(μ c-Si:H) seed layer

Published online by Cambridge University Press:  15 February 2011

W. S. Park ,
Y. H. Jang ,
M. Takeya ,
G. S. Jong  and
T. Ohmi
W. S. Park
Affiliation:
Department of Electronics, Faculty of Engineering, Tohoku University, Aza-Aoba, Aramaki, Sendai 980–77, Japan
Y. H. Jang
Affiliation:
Department of Electronics, Faculty of Engineering, Tohoku University, Aza-Aoba, Aramaki, Sendai 980–77, Japan
M. Takeya
Affiliation:
Department of Electronics, Faculty of Engineering, Tohoku University, Aza-Aoba, Aramaki, Sendai 980–77, Japan
G. S. Jong
Affiliation:
Department of Electronics, Faculty of Engineering, Tohoku University, Aza-Aoba, Aramaki, Sendai 980–77, Japan
T. Ohmi
Affiliation:
Department of Electronics, Faculty of Engineering, Tohoku University, Aza-Aoba, Aramaki, Sendai 980–77, Japan
Get access

Abstract

High quality polycrystalline silicon (poly-Si) films were deposited on SiO2 substrate using hydrogenated microcrystalline silicon (μ c-Si:H) seed layer by very high frequency (182.5MHz) sputtering system and Chemical Vapor Deposition (CVD) system in pure Ar ambient at atemperature of 300°C. In this study, we investigated the correlation between the initial seed layer conditions and the grown layer, and studied the nucleation process. Electrical characteristics and surface roughness of the grown layer as a function of film thickness and deposition rate will be shown. Grown layers were deposited on several kinds of hydrogenated seed layers in pure Ar ambient. The resistivity and Hall mobility of the grown layer are 0.33Ω.cm and 7.5cm2/V-sec respectively for a film with thickness of 3000Å. In this measurement, we found that the resistivity is lower as deposition rate is slower, and when deposition rate is relatively high, the resistivity increases with thickness. On the contrary, in the case of low deposition rate, resistivity decreases as film thickness increases. For the deposition rate of 0.32Å/sec, the surface roughness ranges over 1.39Å-8.52Å. This is a very smooth surface compared to hydrogenated polycrystalline silicon films. The resistivity of grown layer dramatically decreases in proportion to that of the seed layer. From Reflection High Energy Electron Diffraction (RHEED) patterns, it is clearly shown that the film is crystallization of occurred in the earlier stage than that of conventional deposited film. Our results shows that the electrical characteristics of the films are affected by the conditions of the seed layer and the deposition rate. Consequently, we conclude that the initial conditions are very important for the crystal growth of the as-deposition poly-Si.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 467: Symposium A – Amorphous and Microcrystalline Silicon Technology - 1997 , 1997 , 403
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]. Sameshima, T., Hara, M. and Usui, S.: Jpn. J. Appl. Phys. 28 (1989) 1789.Google Scholar
[2]. Hatalis, M.K. and Greve, D.W.: IEEE Electron Device Lett. 8 (1987) 361 Google Scholar
[3]. Shibata, N., Fukuda, K., Ohtoshi, H., Hanna, J, Oda, S. and Shimizu, I.: Jpn. J. Appl. Phys. 26 (1987) L10 Google Scholar
[4]. Akasaka, T. and Shimizu, I.: Appl. Phys. Lett. 66 (1995) 3441 Google Scholar
[5]. Mohri, M., Kakinuma, H., Sakamoto, M. and Sawai, H.: Jpn. J. Appl. Phys. 30 (1991) L779 Google Scholar
[6]. Kakinuma, H., Mohri, M. and Tsuruoka, T., J. Appl. Phys. 77 (1995) 646 Google Scholar
[7]. Yang, Y. H and Abelson, J. R.: Appl. Phys. Lett. 67 (1995) 3623 Google Scholar
[8]. Ohmi, T. and Shibata, T.: Thin Solid Films 241 (1993) 159 Google Scholar
[9]. Hirayama, M., Shindo, W. and Ohrni, T.: Jpn. J. Appl. Phys. 33 (1994) 2272 Google Scholar
[10]. Seto, J.Y.W., J. Appl. Phys. 46 (1975) 5247 Google Scholar
[11]. Kim, Sung Chul, Jung, Moon Hyun and Jang, Jin: Appl. Phys. Lett. 58 (1991) 281 Google Scholar