Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-23T16:17:58.410Z Has data issue: false hasContentIssue false
  • English
  • Français

Fine Keyed Alignment and Bonding for Wafer-Level 3D ICs

Published online by Cambridge University Press:  01 February 2011

Sang Hwui Lee ,
Frank Niklaus ,
J. Jay McMahon ,
Jian Yu ,
Ravi J. Kumar ,
Hui-feng Li ,
Ronald J. Gutmann ,
Timothy S. Cale  and
J.-Q. Lu
Sang Hwui Lee
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, 110 8th St. RPI, CII 6015, Troy, NY, 12180, United States
Frank Niklaus
Affiliation:
[email protected], Royal Institute of Technology, Stockholm, N/A, Sweden
J. Jay McMahon
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
Jian Yu
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
Ravi J. Kumar
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
Hui-feng Li
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
Ronald J. Gutmann
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
Timothy S. Cale
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
J.-Q. Lu
Affiliation:
[email protected], Rensselaer Polytechnic Institute, Center for Integrated Electronics, Troy, NY, 12180, United States
Get access

Abstract

Precise wafer-to-wafer alignment accuracy is crucial to interconnecting circuits on different wafers in three dimensional integrated circuits. We discuss the use of fabricated structures on wafer surfaces to mechanically achieve higher alignment accuracy than can be achieved with our existing (baseline) alignment protocol. The keyed alignment structures rely on structures with tapered side-walls that can slide into each after two wafers are “pre-aligned” using our baseline alignment protocol. Results indicate that alignment accuracy is about a quarter micron, well below the one micron alignment accuracy obtained in our baseline alignment procedure using commercial state-of-the-art wafer alignment equipment. In addition to improving alignment, the alignment structures also hinder undesirable bonding-induced misalignment. The keyed alignment structures are also promising for nano-imprint lithography.

Keywords

bondingmicroelectronicsmicroelectro-mechanical (MEMS)
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 914: Symposium F – Materials, Technology and Reliability of Low-k Dielectrics and Copper Interconnects , 2006 , 0914-F10-05
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

references

1 Lu, J.-Q., Jindal, A., Kwon, Y., McMahon, J.J., Rasco, M., Augur, R., Cale, T.S., Gutmann, R.J., IEEE Proc. IITC 2003, 74–76, Burlingame, USA.Google Scholar
2 Niklaus, F., Enoksson, P., Kälvesten, E., Stemme, G., J. Micromech. and Microeng. 11, 100–107 (2001).Google Scholar
3 Andersson, H., W. Van der Wijngaart, Griss, P., Niklaus, F., Stemme, G., Sensors and Actuators B: Chem. 75(1), 136–141 (2000).Google Scholar
4 Oberhammer, J., Niklaus, F., and Stemme, G., Sensors and Actuators A: Phys. 110(1–3), 407–412 (2004).Google Scholar
5 Mirza, A.R., IEEE Proc. Thermal and Thermomech.Phenomena in Electronic Sys. 2000, 113–119, Las Vegas, USA.Google Scholar
6 Mirza, A.R., IEEE Proc. Electronic Comp. and Tech. 2000, 676–680, Las Vegas, USA.Google Scholar
7 Niklaus, F., Enoksson, P., Kälvesten, E., Stemme, G., Sensors and Actuators A: Physical 107(3), 273-278 (2003).Google Scholar
8 Niklaus, F., Kumar, R.J., McMahon, J.J., Yu, J., Lu, J.-Q., Cale, T.S., Gutmann, R.J., J. Electrochem. Soc. 153(4), G291–G295 (2006).Google Scholar
9 Despont, M., Drechsler, U., Yu, R., Pogge, H.B., Vettiger, P., J. MEMS. 13(6), 895–901 (2004).Google Scholar
10 Smith, R. L., Collins, S.D., Sensors and Actuators 20, 315–316 (1989).Google Scholar
11 Slocum, A.H., Weber, A.C., J. MEMS. 12(6), 826–834 (2003).Google Scholar
12 Zankovych, S., Hoffmann, T., Seekamp, J., Bruch, J.-U., Torres, C.M. Sotomayor, Nanotech. 12, 91–95 (2001).Google Scholar