Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-11-25T17:41:07.023Z Has data issue: false hasContentIssue false
  • English
  • Français

Evaporative Evolution of Brines from Synthetic Topopah Spring Tuff Pore Water, Yucca Mountain, NV

Published online by Cambridge University Press:  11 February 2011

Maureen Alai  and
Susan Carroll
Maureen Alai
Affiliation:
Lawrence Livermore National Laboratory, 7000 East Avenue, Livermore, CA 94550, U.S.A.
Susan Carroll
Affiliation:
Lawrence Livermore National Laboratory, 7000 East Avenue, Livermore, CA 94550, U.S.A.
Get access

Abstract

We are investigating the evaporation of pore water representative of the designated high-level-nuclear-waste repository at Yucca Mountain, NV to predict the range of brine compositions that may contact waste containers. These brines could form potentially corrosive thin films on the containers and impact their long-term integrity. Here we report the geochemistry of a relatively complex synthetic Topopah Spring Tuff pore water that was progressively evaporated in a series of experiments. The experiments were conducted in a vented vessel in which HEPA filtered air flowed over the 95°C solution. Samples of the evaporating solution and the condensed vapor were taken and analyzed to determine the evolving water chemistry and gas volatility. The final solid was analyzed by X-ray diffraction.

The synthetic Topopah Spring Tuff water evolved towards a complex brine that contained about 45 mol % Cl, 7 mol% NO3, 43 mol% Na, 4 mol % K, and less than 1 mol % each of SO4, Ca, Mg, HCO3 and Si. Trends in the solution data and identification of CaSO4 solids suggest that fluorite, carbonate, sulfate, and Mg-silicate precipitation minimize the corrosion potential of “sulfate type pore water” by removing F, Ca, and Mg during the early stages of evaporation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 757: Symposium II – Scientific Basis for Nuclear Waste Management XXVI , 2002 , II11.6
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Bechtel SAIC Company (2001) FY01 Supplemental Science and Performance Analysis, V. 1 Scientific Basis and Analyses, Report #TDR-MGR-MD-000007 REV 0, p. 6–56 to 6–59.Google Scholar
Brossia, C. S. and Kelly, R. G. (1998) Influence of alloy sulfur content and bulk electrolyte composition on crevice corrosion initiation of austenitic stainless steel. Corrosion, 54, 145–154.Google Scholar
Eugster, H.P. and Hardie, L.A. (1978) Saline lakes, In: Lerman, A. (Ed.), Lakes: Chemistry, Geology, Physics, Springer-Verlag, New York.Google Scholar
Hardie, L.A. and Eugster, H. P. (1970) The evolution of closed-basin brines. Mineral Society Amer. Spec. Pap. 3, 273–290.Google Scholar
Li, J., Lowenstein, T. K., and Blackburn, I. R. (1997) Responses of evaporite mineralogy to inflow water sources and climate during the past 100 k.y. in Death Valley, California. GSA Bulletin, 109, 1361–1371.Google Scholar
Peterman, Zell E., and Marshall, Brian D., 2002, Geochemistry of pore water from densely welded Topopah Spring Tuff at Yucca Mountain, Nevada (abs): Geological Society of America Abstracts with Programs: v. 34, n. 6, p. 308.Google Scholar
Rosenberg, N.D., Gdowski, G. E., and Knauss, K.G. (2001). Evaporative chemical evolution of natural waters at Yucca Mountain, Nevada. Applied Geochemistry, 16, 1231–1240.Google Scholar
Yang, I. C., Rattray, G. W., and Yu, P. (1996) Interpretation of Chemical and Isotopic Data From Boreholes in the Unsaturated Zone at Yucca Mountain, Nevada. USGS, Water-Resources Investigations Report 96–4058 (Tables 2 and 3).Google Scholar