Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-20T00:46:49.663Z Has data issue: false hasContentIssue false
  • English
  • Français

Emulsion Precipitation and Characterization of Zirconia

Published online by Cambridge University Press:  28 February 2011

Lieh-Jiun Shyu  and
Frank M. Cambria
Lieh-Jiun Shyu
Affiliation:
Akzo Chemicals Inc., Livingstone Ave., Dobbs Ferry, NY 10522
Frank M. Cambria
Affiliation:
Akzo Chemicals Inc., Livingstone Ave., Dobbs Ferry, NY 10522
Get access

Abstract

Zirconia and yttria-stabilized zirconia (YSZ) powders were prepared from water/oil emulsions followed by high temperature calcination. The morphology and particle size were correlated with several variables such as composition of emulsions, concentration of starting materials and surfactants, stirring rate, hydrolysis rate and calcination temperature. The powders were characterized according to crystalline phase, particle size distribution, and flow rate. Emulsion precipitation typically yielded spherical zirconia particles which were either solid or hollow. Particle size could be controlled from submicron to a few hundred microns depending primarily on the composition of the emulsion and stirring rate during hydrolysis. SEM/EDX results showed that yttria was uniformly distributed throughout the zirconia particles. The crystalline phase of the powders after calcination at 800°C was entirely non-transformable tetragonal. The flow rate increased with increasing particle size and with increasing sphericity.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 180: Symposium A – Better Ceramics Through Chemistry IV , 1990 , 837
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Bratton, R. J. and Lau, S. K., Adv. Ceram., Edited by Heuer, A. H. and Hobbs, L. W., 3, 226–240. 1981.Google Scholar
2. Rhodes, W. H. and Natansohn, S., Ceram. Bull., 68 (10), 1804–1812, 1989.Google Scholar
3. Keller, R. J., Research and Development for Improved Thermal Barrier Coatings, Report No. AFWAL-TR-4008, April 1984.Google Scholar
4. Subbarao, E. C., Adv. Ceram., Edited by Heuer, A. H. and Hobbs, L. W., 3, 1–24, 1981.Google Scholar
5. Akinc, M. and Richardson, K., Mat. Res. Soc. Symp. Proc., 73, 99–109, 1986.Google Scholar
6. Reynen, P., Bastius, H. and Fiedler, M., Ceramic Powders, Elsevier Scientific Publishing Co., Amsterdam, p. 405, 1983.Google Scholar
7. Hardy, A. R., Gowda, G., McMahon, T. J., Riman, R. E., Rhine, W. E., and Bowen, H. K., Preparation of oxide powders, John Wiley & Sons, Inc. New York, NY 1987.Google Scholar
8. Muraleedharan, K. and Subrahmanyam, J., J. Am. Ceram. Soc., 71 (5), C226–C227, 1988.Google Scholar