Hostname: page-component-78c5997874-t5tsf Total loading time: 0 Render date: 2024-11-20T02:30:37.204Z Has data issue: false hasContentIssue false
  • English
  • Français

Eliipsometric Study of Rapid Thermal Annealed PECVD SiN Films

Published online by Cambridge University Press:  22 February 2011

Samuel A. Alterovitz ,
Mark A. Drotos  and
Paul G. Young
Samuel A. Alterovitz
Affiliation:
NASA Lewis Research Center, Cleveland, Ohio 44135
Mark A. Drotos
Affiliation:
Undergraduate student intern at NASA Lewis Research Center from Cleveland State University, Dept. of Electrical Engineering, Cleveland, Ohio 44115
Paul G. Young
Affiliation:
Electrical Engineering Dept., University of Toledo, Toledo, Ohio 43606
Get access

Abstract

A conventional parallel plate plasma enhanced chemical vapor deposition system using SiH4-NH3-N2 at 13.56MHz and 300°C was used to deposit SiN films on silicon substrates. Special care was used to assure an oxide free surface before deposition. The silane flow was varied to obtain stoichiometric Si3 N4 and silicon-rich films. Rapid thermal anneal (RTA) was performed for 30 sec at temperatures in the range 600°C — 900°C. Spectroscopic ellipsometry was used to characterize the films. Data was taken for 44 wavelengths (3200–7500Å range) at three angles of incidence on each sample. The structural and optical properties were obtained using several structural models of the film. The models assumed an effective medium approximation for the following three combinations of film constituents: Si3N4 and voids; Si3N4 and amorphous silicon (a-Si); Si3N4, voids and a-Si. In general, the three constituent model gave the best fits to the experimental data. In all films, we observed a decrease in the film thickness and void fraction as the RTA temperature increased. The a-Si percentage did not change vs. the RTA temperature. The reduction in void fraction for the silicon-rich samples was larger than for the Si3N4 film. The results are comparable to those measured by other methods on regular furnace annealed SiN films, i.e. annealing times of 30 minutes or more.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 284: Symposium G – Amorphous Insulating Thin Films , 1992 , 45
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Bartle, D.C., Andrews, D.C., Grange, J.D., Trigy, A.D. and Wickenden, D.K., Vacuum, 34, 315 (1984).Google Scholar
2. Dharmadhikari, V.S., Thin Solid Films, 153, 59 (1987).Google Scholar
3. Domansky, K., Petelenz, D. and Jamata, J., Appl. Phys. Lett. 2074 (1992).Google Scholar
4. Stein, H.J., Walls, V.A. and Hampy, R.E., J. Electrochem, Soc. 126, 1750 (1979).Google Scholar
5. Claasen, W.A.P., Valkenburg, W.G.J.N., Willemsen, M.F.C. and Wijgert, W.M.v.d., J. Electrochem. Sic. 132, 893 (1985).Google Scholar
6. Kuiper, A.E.T., Willemsens, M.F.C. and Van Ijzendoom, L.J., Appl. Phys. Lett. 53, 2149 (1988).Google Scholar
7. Watanabe, H., Katoh, K. and Imagi, S.-I., Thin Solid Films, 136, 77 (1986).Google Scholar
8. Nguyen, S.V. and Fridman, S., J. Electrochem, Soc. 134, 2334, (1987).Google Scholar
9. Osenbach, J.W., Zell, J.L., Knolle, W.R. and Howard, L.J., J. Appl. Phys. 67, 6830 (1990).Google Scholar
10. Theeten, J.B., Aspnes, D.E., Simondet, F., Erman, M. and Murau, P.C., J. Appl. Phys. 52, 6788 (1981).Google Scholar
11. Habraken, F.H.P.M., Kuiper, A.E.T., Tajminga, Y. and Theeten, J.B., J. Appl. Phys. 53, 6996 (1982).Google Scholar
12. Alterovitz, S.A., Bu-Abbud, G.H., Woollam, J.A. and Liu, D.C., J. Appl. Phys. 54, 1559 (1983).Google Scholar
13. Xiong, Y.M., Synder, P.G., Woollam, J. A. and Krosche, E.R., J. Vac. Sci. Technol. A10, 950 (1992).Google Scholar
14. Aspnes, D.E., Theeten, J.B. and Hottier, F., Phys. Rev. B20, 3292 (1979).Google Scholar
15. Aspnes, D.E., Theeten, J. B., J. Appl. Phys. 50, 4928 (1979).Google Scholar
16. Sanchez, O., Gomez - Aleixandre, C., Fernandez, M. and Abella, J.M., Vacuum 9, 727 (1989).Google Scholar
17. Grundner, M. and Jacob, H., Appl. Phys. A39, 73 (1986).Google Scholar
18. Alterovitz, S.A., Sieg, R.M., Shoemaker, N.S. and Pouch, J.J., Mat. Res. Soc. Symp. Proc. 152, 21 (1989).Google Scholar
19. Bu-Abbud, G.H., Bashara, N.M. and Woollam, J.A., Thin Solid Films, 138, 27, (1986).Google Scholar