Hostname: page-component-586b7cd67f-t8hqh Total loading time: 0 Render date: 2024-11-29T09:36:31.687Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of Process Parameters on the Ablated Flux Characteristics During Pulsed-Laser Ablation of Lead Zirconate Titanate (PZT)

Published online by Cambridge University Press:  21 February 2011

D.J. Lichtenwalner ,
O. Auciello ,
R. Dat ,
R. Barnes ,
A.F. Schreiner ,
O.E. Hankins  and
A.I. Kingon
D.J. Lichtenwalner
Affiliation:
Dept. of Mat. Sci. and Eng., North Carolina State University, Raleigh, NC 27695
O. Auciello
Affiliation:
Dept. of Mat. Sci. and Eng., North Carolina State University, Raleigh, NC 27695 MCNC Center for Microelectronics, Research Triangle Park, NC 27709
R. Dat
Affiliation:
Dept. of Mat. Sci. and Eng., North Carolina State University, Raleigh, NC 27695
R. Barnes
Affiliation:
Dept. of Chemistry, North Carolina State University, Raleigh, NC 27695
A.F. Schreiner
Affiliation:
Dept. of Chemistry, North Carolina State University, Raleigh, NC 27695
O.E. Hankins
Affiliation:
Dept. of Nuclear Engineering, North Carolina State University, Raleigh, NC 27695
A.I. Kingon
Affiliation:
Dept. of Mat. Sci. and Eng., North Carolina State University, Raleigh, NC 27695
Get access

Abstract

We have investigated the ablated flux characteristics of PbZrxTi1-xO3 as a function of deposition process parameters. The ablation-deposition rate, angular distribution, and type of ablated species axe all affected by the oxygen gas pressure. Visually, a change in the shape and color of the ablation plume are evident upon adding oxygen gas. The ablated flux distribution narrows as the oxygen pressure is increased, from a cos40θ distribution in a low gas pressure, up to a cos 260θ distribution at an oxygen pressure of 300 mTorr. This narrowing, or focusing, of the ablated plume also results in an increased deposition rate along the plume centerline for high laser power. However, at low laser power the deposition rate decreases as the pressure is increased, due to gas scattering effects. The energy of depositing species and the ratio of deposition flux to O2 flux will then be very different in each of these two regimes. The species in the plume have been examined using optical emission spectroscopy. We have found that mostly atomic species are present, but the ratio of ions to neutrals is very different for the Pb, Zr, and Ti atoms. Therefore, the application of electric fields near the substrate would affect the film composition to some degree.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 310: Symposium N – Ferroelectric Thin Films III , 1993 , 481
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Ramesh, R., Chan, W.K., Wilkens, B., Gilchrist, H., Sands, T., Tarascon, J.M., Keramides, V.G., Fork, D.K., Lee, J., and Safari, A., Appl. Phys. Lett. 61, 1537 (1992).CrossRefGoogle Scholar
[2] Cheung, J.T. and Sankur, H., CRC Critical Rev. in Sol. State and Mat. Sci., 15(1), 63 (1988).CrossRefGoogle Scholar
[3] Chan, C.L. and Mazumder, J., J. Appl. Phys. 62, 4579 (1987).CrossRefGoogle Scholar
[4] Venkatesan, T., Wu, X.D., Inam, A., and Wachtman, J.B., Appl. Phys. Lett. 52, 1193 (1988).CrossRefGoogle Scholar
[5] Auciello, O., Athavale, S., Hankins, O.E., Sito, M., Schreiner, A.F., and Biunno, N., Appl. Phys. Lett. 53, 72 (1988).CrossRefGoogle Scholar
[6] Geohegan, D.B., Appl. Phys. Lett. 60, 2732 (1992).CrossRefGoogle Scholar
[7] Fried, D., Reck, G.P., Kushida, T., and Rothe, E.W., J. Phys. D: Appl. Phys. 24, 1065 (1991).CrossRefGoogle Scholar
[8] Horwitz, J.S., Grabowski, K.S., Chrisey, D.B., and Leuchtner, R.E., Appl. Phys. Lett. 59, 1565 (1991).CrossRefGoogle Scholar
[9] Leuchtner, R.E., Horwitz, J.S., and Chrisey, D.B., in Ferroelectric Thin Films II, edited by Kingon, A.I., Myers, E.R., and Tuttle, B., Mater. Res. Soc. Proc. 243, Pittsburgh PA 1992), pp 525–530.Google Scholar
[10] Auciello, O., Emerick, J., Duarte, J., and Illingworth, A., J. Vac. Sci. Technol. A 11, 267 (1993).CrossRefGoogle Scholar