Hostname: page-component-586b7cd67f-2brh9 Total loading time: 0 Render date: 2024-11-25T15:44:55.503Z Has data issue: false hasContentIssue false
  • English
  • Français

The Effects of Film Thickness and Texture on the high and Low-Field stress Response of Lead Zirconate Titanate Thin Films

Published online by Cambridge University Press:  10 February 2011

J. F. Shepard Jr ,
F. Chu ,
B. Xu  and
S. Trolier-McKinstry
J. F. Shepard Jr
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
F. Chu
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
B. Xu
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
S. Trolier-McKinstry
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
Get access

Abstract

Lead zirconate titanate (PZT) thin films are currently employed in non-volatile ferroelectric memories (FRAM's) and are intended to be used as the active material in a number of microelectromechanical systems (MEMS). Several groups have reported that both the piezoelectric and dielectric characteristics of ferroelectric thin films improve with an increase of film thickness, though the reasons for those improvements are unclear. Previous investigations on the effects of biaxial mechanical stress indicate that non-180° domain wall motion is limited in PZT 52/48 films less than 0.5 μm thick. It is possible that some of the improvements of the dielectric and piezoelectric characteristics reported for thicker films (i.e. films thicker than 0.5 μm) are associated with an increase of extrinsic contributions to the properties. To evaluate domain wall mobility in thicker films, the high and low-field stress response of sol-gel PZT fabricated with either rapid thermal processing or conventional furnace annealing were investigated. Films with thicknesses ranging from 0.6 to 5.0 μm thick were measured as a function of applied biaxial stress (±110 MPa). It was found that for all films tested the changes of capacitance were on the order of 2–3%. High-field measurements showed: (1) the coercive field to be insensitive to applied stress, (2) remanent polarizations to decrease about 20% at the maximum applied tension, (3) remanent polarizations to increase less than 10% with applied compression, and (4) all changes to be reversible over the stress range investigated. These results suggest that extrinsic contributions are limited for the films tested.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 493: Symposium U – Ferroelectric Thin Film VI , 1997 , 81
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Kholkin, A. L., Wutchrich, C., Taylor, D. V., and Setter, N., “Interferometrie Measurements of Electric Field-Induced Displacements in Piezoelectric Thin Films,” Rev. Sei. Instrum., Vol. 67, pp. 1935–1941, 1996.Google Scholar
[2] Eatough, M. O., Dimos, D., Tutele, B. A., and Warren, W. L., “A Study of Switching Behavior in Pb(Zr,Ti)O3 Thin Films Using X-Ray Diffraction,” Mat. Res. Soc. Symp. Proc., vol. 361, pp. 111–116, 1995.Google Scholar
[3] Shepard, J. F. Jr, Trolier-McKinstry, S., and Maria, J. P., “The Effects of Applied Biaxial Stress on the Low and High-Field Characteristics of Thin Film PZT,” submitted to J. Mat. Res., 1997.Google Scholar
[4] Chen, H. D., Udayakumar, K. R., Gaskey, C. J., and Cross, L. E., “Fabrication and Electrical Properties of Lead Zirconate Titanate Thick Films,” J. Am. Ceram. Soc., Vol. 79, pp. 2189–2192, 1996.Google Scholar
[5] Udayakumar, K. R. et al., “Thickness-Dependent Electrical Characteristics of Lead Zirconate Titanate Thin Films,” J. Appl. Phys., Vol. 77, pp. 3981–3986, 1995.Google Scholar
[6] Chu, F., Su, T., and Trolier-McKinstry, S., “Effect of Thickness and Texture on the Ferroelectric Properties of Lead Zirconate Titanate Thin Films by Sol-Gel Processing,” The 8th US-Japan Seminar on Dielectric and Piezoelectric Ceramics, Plymouth, Mass., 1997.Google Scholar
[7] Brown, R. F., “Effect of Two-Dimensional Mechanical Stress on the Dielectric Properties of Poled Ceramic Barium Titanate and Lead Zirconate Titanate,” Can. J. Phys., vol. 39, pp. 741–753, 1961. 181Google Scholar
[8] Shepard, J. F. Jr and Trolier-McKinstry, S., “The Low-Field Biaxial Stress Response and Transverse Piezoelectric Coefficients of Sol-Gel PZT Thin Films,” The 8th US-Japan Seminar on Dielectric and Piezoelectric Ceramics, Plymouth, Mass., 1997.Google Scholar