Hostname: page-component-78c5997874-8bhkd Total loading time: 0 Render date: 2024-11-09T03:22:44.868Z Has data issue: false hasContentIssue false

The Effect of Surface Finishing on the Tribological Behavior of a 94% Alumina Ceramic Material

Published online by Cambridge University Press:  28 February 2011

Jeffrey L. Spodnik
Affiliation:
Vanderbilt University, Dept. of Materials Science and Engineering, Olin Hall, Rm. 302, Nashville, TN 37212
James J. Wert
Affiliation:
Vanderbilt University, Dept. of Materials Science and Engineering, P.O. Box 1621, Station B, Nashville, TN 37235
Get access

Abstract

The effect of surface finish on the unlubricated sliding wear behavior of a 94% A12O3 ceramic material has been investigated using a reciprocatingright cylinder-on-flat tribometer. The surface finishes evaluated were produced using a combinationof SiC and diamond abrasive particles.

Profilometry was employed to characterize surface topography and x-ray diffraction was used to determine the residual stress associated with each finishing process.

The coefficients of friction and controlling wear mechanisms varied dramatically as the maximum asperity height was altered by different finishing techniques. Below a peak profile of 0.25 μm, the coefficient of friction varied between 0.60 and 0.75 due to preferential shearing of the siliceous binder phase which segregated at surfacial pores and grain boundaries. Binder adhesion in the sliding contact produced stick-slip frictional behavior. Surfaces with asperity heights in excess of 10 μin exhibited intergranularfracture or grain “pluck-out”. These surfaces contained minimal real areas of contact and yielded friction coefficients of 0.30 - 0.35. Removed alumina grains actedas hard abrasives in the contact zone and enhanced transgranular fracture by a lateral cracking mechanism. Evidence of crack propagation as a result of Mode II and Mode III shearloading was discovered at subsurface pore sites. The influences of microindentation hardness and fracture toughness are discussed in terms of their relative importances on the observed wear behavior.

Type
Research Article
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Gentle, C. and Juden, H., Engineering in Medicine, 13 (2), 79, (1984).CrossRefGoogle Scholar
2. Kim, S., Kato, K., Hokkirigawa, K., Abe, H., Trans. of ASME 108, 44, (1986).Google Scholar
3. Sheppard, L., Adv. Mat. Processes 1 (3), 44, (1985).Google Scholar
4. Krell, A., Wotersdorf, J., Pippel, F., Schulze, D., Phil. Mag. 4 51 (5), 765, (1985).CrossRefGoogle Scholar
5. Gruver, R., Kirchner, H., Jrnl. Amer. Ceramic Soc. 56 (1), 21, (1973).CrossRefGoogle Scholar