Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-23T09:08:10.900Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of Slag on Mixing Time in Gas-Stirred Ladles Assisted with a Physical Model

Published online by Cambridge University Press:  01 March 2013

Adrián M. Amaro-Villeda ,
A. Conejo  and
Marco A. Ramírez-Argáez
Adrián M. Amaro-Villeda
Affiliation:
Facultad de Química, Universidad Nacional Autónoma de México, Mexico City, [email protected], [email protected]
A. Conejo
Affiliation:
Centro de Graduados, Instituto Tecnológico de Morelia, Avenida Tecnológico 1500, Col Lomas de Santiaguito, Morelia, Michoacán, México.
Marco A. Ramírez-Argáez
Affiliation:
Facultad de Química, Universidad Nacional Autónoma de México, Mexico City, [email protected], [email protected]
Get access

Abstract

A 1/6th water physical model of a 140 tons gas-stirred steel ladle is used to evaluate mixing times (τm at 95% of chemical uniformity) in a two phase system without slag (air-water) and in a more realistic three phase system (air-water-oil) to simulate the argon-steel-slag system and quantify the effect of the slag layer on the mixing time. Slag layer is kept constant at 0.004 m. Mixing times are estimated through measured changes in pH due to the addition of a tracer (NaOH 1 M). The effect of the following variables on the mixing time is evaluated for a single injector: gas flow rate (7, 17 y 37 l/min) and the injector position (R/r= 0, 1/3, ½, 2/3 and 4/5). Experimental results obtained in this work show good agreement when compared against mixing time correlations reported by Mazumdar for the two phase air-water case (no slag considered). Another comparison is done using the new concept called “effective bath height” proposed by Barati, where the mixing time is a function of the size of the slag layer since this layer dissipates part of the total amount of stirring energy introduced into the ladle by the injection of gas. Agreement is not good in this case. Finally, an estimation of the percentage of the stirring energy dissipated by the slag is computed, including other factors that govern the dissipation of stirring energy. Percentage of energy dissipated by the slag is found to be between 2.7 to 12 % depending on the process conditions.

Keywords

kineticssteelmixtures
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1485: Symposium 7D – Advanced Structural Materials—2012 , 2012 , pp. 101 - 106
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Mazumdar, D. and Guthrie, R., “The physical and mathematical modelling of gas stirred ladle Systems,” ISIJ int. 35 No.1, 1 (1995).CrossRefGoogle Scholar
Mazumdar, D. and Evans, J. W.: Macroscopic models for gas stirred ladles, ISIJ Int. 44 No.3, 447 (2004).CrossRefGoogle Scholar
Han, J. W., Heo, S. H., Kam, D. H., You, B. D. Pak, J. J. and Song, H. S.: Transient fluid flow phenomena in a gas stirred liquid bath with top oil layer-approach by numerical simulation and water model experiments, ISIJ Int., 41 No. 10, 1165 (2001).CrossRefGoogle Scholar
Krishnapisharody, K. and Irons, G. A., “Modeling of slag eye formation over a metal bath due to gas bubbling,” Metall. Trans., 37B, 763 (2006).CrossRefGoogle Scholar
Dayal, P., Beskow, K., Björkvall, J. and Sichen, D., “Study of slag/metal interface in ladle treatment,” Ironmaking & Steelmaking, 33, No.6, 454 (2006).CrossRefGoogle Scholar
Thunman, M., Eckert, S., Hennig, O., Björkvall, J. and Sichen, D., “Study on the formation of open-eye and slag entrainment in gas stirred ladle,” Steel research int. 78 No. 12, 849 (2007).CrossRefGoogle Scholar
Khajavi, L. T. and Barati, M., “Liquid mixing in thick-slag-covered metallurgical baths-blending of bath,” Metall. Trans., 41B, 86 (2010).CrossRefGoogle Scholar
Mazumdar, D. and Guthrie, R. I. L., “Modeling Energy Dissipation in slag-covered steel baths in steelmaking ladles,” Metall. Trans., 41B, 976 (2010).CrossRefGoogle Scholar
Kishimoto, Y., Sheng, Y., Irons, G. A. and Chang, Jen-Shih: “Energy dissipation distribution in gas-stirred liquids”, ISIJ Int. 39 No.2, 113 (1999).CrossRefGoogle Scholar
Amaro-Villeda, A. M., González, J. A., Ramírez-Argáez, M. A.: “Experimental study in gas-stirred ladles with and without the slag phase trough a water physical model,” Mater. Res. Soc. Symp. Proc. Vol. 1373, 155 (2012).CrossRefGoogle Scholar