Hostname: page-component-7bb8b95d7b-w7rtg Total loading time: 0 Render date: 2024-09-12T16:55:31.083Z Has data issue: false hasContentIssue false
  • English
  • Français

Ductility and Fracture Behavior of Single Crystalline Ni3Al with Boron Additions

Published online by Cambridge University Press:  26 February 2011

F. E. Heredia  and
D. P. Pope
F. E. Heredia
Affiliation:
University of Pennsylvania, Department of Materials Science and Engineering, 3231 Walnut Street, Philadelphia, Pa. 19104.
D. P. Pope
Affiliation:
University of Pennsylvania, Department of Materials Science and Engineering, 3231 Walnut Street, Philadelphia, Pa. 19104.
Get access

Abstract

Low and high temperature tensile tests were performed on single crystals of pure Ni3Al and Ni3Al+B in order to determine the effect of B additions on the ductility and fracture behavior. Tests were carried out in air at a constant strain rate of 1.3 × 10−3 s−1. The orientations tested were [001] for which the yield stress in tension is always greater than in compression, and those for which the tension/compression asymmetry is zero ([T=C]) for each particular composition. At room temperature, the results show a positive effect of B additions on both the fracture stress and on the ductility. The ductility at 800K appears to decrease monotonically with B additions. The largest ductilities are found for [T=C] at room temperature where an improvement of about 26% (resolved strain) for an addition of 0.2 at% B was obtained. However, the most dramatic increase in ductility occurs for the [001] oriented samples at room temperature where a 55% improvement was measured over that of pure Ni3Al. Fracture surfaces show a combination of massive slip, some cleavage, and heavily dimpled areas. These observations show that B additions not only increase the ductility of polycrystalline Ni3Al, as has been previously observed by many investigators, but also that of the already-ductile single crystalline material, indicating that a “bulk effect” should be added to the grain boundary strengthening effect of B when explaining the improvement in ductility of polycrystalline Ni3Al due to B additions.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 133: Symposium H – High-Temperature Ordered Intermetallic Alloys III , 1988 , 287
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Copley, S. M. and Kear, B. H., Trans. AIME, 232. 977 (1967).Google Scholar
2. Aoki, K. and Izumi, O., Nippon Kinzoku Gakkaishi, 43, 1190 (1979).Google Scholar
3. Liu, C. T., Proc. MRS Symp. High-Temperature Ordered Intermetallic Alloys II, vol.81, pp. 355, MRS Publication (1987).Google Scholar
4. Takasugi, T., George, E., Pope, D. P., and Izumi, O., Scr. Metall., 19, 551 (1985).Google Scholar
5. Ogura, T., Hanada, S., Masumoto, T. and Izumi, O., Metall. Trans.,16A, 441 (1985).CrossRefGoogle Scholar
6. Liu, C. T., White, C. L., and Horton, J. A., Acta Metall., 33, 213 (1985).Google Scholar
7. White, C. L. and Choudhury, A., MRS Symp. High-Temperature Ordered Intermetallic Alloys II, vol.81, pp. 427, MRS Publication (1987).Google Scholar
8. Schulson, E. M., Weihs, T. P., Baker, I., Frost, H. J., and Horton, J. A., Acta Metall., 34, 1395 (1986).CrossRefGoogle Scholar
9. Baker, I., Huang, B., and Schulson, E. M., Acta Metall., 36, 493 (1988).Google Scholar
10. Heredia, F. E. and Pope, D. P., Proceedings of The 6th Int..Symposium on Superalloys, 1988, Champion, Pennsylvania, USA.Google Scholar