Hostname: page-component-cd9895bd7-hc48f Total loading time: 0 Render date: 2024-12-27T02:10:48.487Z Has data issue: false hasContentIssue false
  • English
  • Français

Direct observation and characterisation of the oxide nanostructured interface resulting from organosilane pre-treatment of aluminium

Published online by Cambridge University Press:  11 February 2011

Mark J. Whiting ,
Vlad Stolojan ,
Ann Rattana  and
John F. Watts
Mark J. Whiting
Affiliation:
Centre for Advanced Surface, Particle and Interface Analysis, School of Engineering, University of Surrey, Guildford, Surrey, UK
Vlad Stolojan
Affiliation:
Centre for Advanced Surface, Particle and Interface Analysis, School of Engineering, University of Surrey, Guildford, Surrey, UK
Ann Rattana
Affiliation:
Centre for Advanced Surface, Particle and Interface Analysis, School of Engineering, University of Surrey, Guildford, Surrey, UK
John F. Watts
Affiliation:
Centre for Advanced Surface, Particle and Interface Analysis, School of Engineering, University of Surrey, Guildford, Surrey, UK
Get access

Abstract

The pre-treatment of aluminium surfaces prior to adhesive bonding and coating processes is of major technological significance. However, the two major commercial pre-treatments, chromic acid and phosphoric acid anodising, both make use of Cr(VI) containing solutions with the attendant problems of waste disposal. The disposal of this harmful solution poses severe environmental problems. Therefore, other environmentally friendly alternatives are being investigated, one of the most popular candidates is the use of one-step pretreatment processes based on organosilane adhesion promoters.

This study examines a model system made from polished aluminium sheet treated with an organosilane; γ-glcidoxypropyltrimethoxysilane (GPS). The interface was characterised by TEM carried out on microtomed sections. The information gained from imaging and Electron Energy Loss Spectroscopy (EELS) analysis revealed a layer of oxide, approximately 70 nm thick. Silicon was found to have been incorporated within this oxide layer. Thus it is suggested that during the curing of the GPS, at elevated temperature, growth of aluminium oxide takes place which gives rise to an Al/O/Si phase.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 734: Symposia A/B – Defect-Mediated Phenomena in Ordered Polymers – Polymer/Metal Interfaces and Defect Mediated Phenomena in Ordered Polymers , 2002 , B1.8
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Digby, R. P. and Shaw, S. J., Int. J. Adhes. Adhes. 18, 261 (1998).CrossRefGoogle Scholar
2. Abel, M-L., Digby, R. P., Fletcher, I. W. and Watts, J. F., Surf. Interface Anal. 29, 115 (2000).3.0.CO;2-6>CrossRefGoogle Scholar
3. Abel, M-L., Rattana, A. and Watts, J. F., Langmuir 16, 6511 (2000).CrossRefGoogle Scholar