Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-25T18:55:48.587Z Has data issue: false hasContentIssue false

Deposition and Characterization of Y3Al5O12 (YAG) Films and Powders by Plasma Spray Synthesis

Published online by Cambridge University Press:  18 March 2011

Sujatha D. Parukuttyammaa
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering
Joshua Margolis
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering
Haiming Liu
Affiliation:
Department of Chemistry
John B. Parise
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering Department of Chemistry Department of Geosciences, State University of New York at Stony Brook, Stony Brook, New York 11794-2275, U. S. A.
Clare P. Grey
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering Department of Chemistry
Sanjay Sampath
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering
Perina Gouma
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering
Herbert Herman
Affiliation:
Center for Thermal Spray Research, Department of Materials Science and Engineering
Get access

Abstract

YAG powders and coatings were developed for the first time by a novel precursor plasma spraying technique using the radio frequency (RF) induction plasma technique. The XRD of the as -sprayed coating confirms the presence of YAG, H-YAP or O-YAP or a mixture of the above depending on the spray conditions. 27Al MAS NMR of the YAG coating corroborates the x-ray results. TEM studies on the coatings confirm that the coating consists of nano-structured particles. The successful spraying of these complex oxide coatings proves that chemistry of phase formation can be controlled in the plasma, thus opening up new avenues in material synthesis.

Type
Research Article
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Herman, H. and Sampath, S., Metallurgical and Ceramic Protective Coatings, Ed (Stern, K. H.) 261289 (1996).Google Scholar
2. Schiller, G., Muller, M. and Gitzhofer, F., J. Therm. Spray. Tech., 8[3] 389392 (1999).Google Scholar
3. Corman, G. S., Ceram. Eng. Sci. Proc., 12, 17451766 (1991).Google Scholar
4. Wang, H., Gao, L. and Niihara, K., Mater. Sci. Eng. A., 288, 14 (2000).Google Scholar
5. Veith, M., Mathur, S., Kareiva, A., Jilavi, M., Zimmer, M. and Huch, V., J. Mater. Chem., 79[2] 385394 (2000).Google Scholar
6. Cinibulk, M. K., J. Am. Ceram. Soc., 83[5] 12761278 (2000).Google Scholar
7. P, Sujatha Devi.et al., Manuscript in preparation.Google Scholar
8. P, Sujatha Devi., Margolis, J., Liu, H., Grey, C. P., Sampath, S., Herman, H. and Parise, J. B.., J. Am. Ceram. Soc., (Communicated).Google Scholar