Hostname: page-component-78c5997874-t5tsf Total loading time: 0 Render date: 2024-11-05T09:40:32.860Z Has data issue: false hasContentIssue false

Defects Related To Electrical-Leakage In Tmos Structures

Published online by Cambridge University Press:  21 February 2011

Lynnita Knoch
Affiliation:
Motorola Inc., Advanced Custom Technologies, 2200 W. Broadway Rd., M350, Mesa, AZ 85202;
N. David Theodore
Affiliation:
Motorola Inc., Materials Research and Strategic Technologies, M360, Mesa, AZ 85202;
Pak Tam
Affiliation:
Motorola Inc., Advanced Custom Technologies, 2200 W. Broadway Rd., M350, Mesa, AZ 85202;
Taku Yamamoto
Affiliation:
Nippon Motorola Inc., 1 Ooyaji Kofune Shiokawa-machi, Yama-gun, Fukushima-ken 969-35, Japan.
Get access

Abstract

TMOS devices for power applications use ion-implantation for doped layers. Implant-damage can increase electrical leakage of devices. Transmission electron microscopy was used to study the effect of dose (4E14 - 2E15 cm-2) and energy (20-40 keV) of p+ implants on damage related to leakage in TMOS structures. TEM reveals a high density of boron implant-induced defects such as end-of-range and peak-of-implant damage, boron implant-induced stacking faults and dislocations. End-of-range defects also arise from an arsenic implant, and mask-edge defects arise where arsenic-amorphized Si and crystalline Si meet in the source region. Some defects extend >0.5 μπι into the substrate. The density and the extent of defect penetration decrease with decreasing implant-dose and energy. These data correlate well with the electrical data, which show that Idss leakage decreases with decreasing p+ implant-energy and dose.

Type
Research Article
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Guldi, R.L, J. Electrochem. Soc. 141 (7), 1957 (1994).Google Scholar
2 Liefting, R., Wijburg, R.M., Custer, J.S., Wallinga, H., Saris., F.W., IEEE Trans. Elect. Dev. 41(1), 50 (1994).Google Scholar
3 Cerva, H., Bergholz, W., J. Electrochem. Soc. 140 (3), 780 (1993).Google Scholar
4 Mikoshiba, H., Nishio, N., Matsumoto, T., Kikuchi, H., Kitano, T., Kaneko, H., Mat. Res. Soc. Symp. Proc. Vol. 262, 629 (1992).Google Scholar