Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-05T14:12:48.131Z Has data issue: false hasContentIssue false

CuO and Cu2O Nanoparticles for Thin Film Photovoltaics

Published online by Cambridge University Press:  29 August 2013

Jan Flohre
Affiliation:
Institute of Energy and Climate Research 5 -Photovoltaics-, Forschungszentrum Jülich GmbH, D-52425 Jülich Germany
Maurice Nuys
Affiliation:
Institute of Energy and Climate Research 5 -Photovoltaics-, Forschungszentrum Jülich GmbH, D-52425 Jülich Germany
Christine Leidinger
Affiliation:
Institute of Energy and Climate Research 5 -Photovoltaics-, Forschungszentrum Jülich GmbH, D-52425 Jülich Germany
Florian Köhler
Affiliation:
Institute of Energy and Climate Research 5 -Photovoltaics-, Forschungszentrum Jülich GmbH, D-52425 Jülich Germany
Reinhard Carius
Affiliation:
Institute of Energy and Climate Research 5 -Photovoltaics-, Forschungszentrum Jülich GmbH, D-52425 Jülich Germany
Get access

Abstract

Laser annealing experiments on commercially available phase pure tenorite (CuO) nanoparticles (NPs) were performed in air and nitrogen atmosphere to improve the structural and electronic properties, with respect to their suitability for photovoltaic applications. The particles exhibit size variations from about 30 nm to 100 nm. The influence of the thermal treatment is investigated by photoluminescence (PL) and Raman spectroscopy. Annealing of the particles in air by a laser treatment improved the material quality by defect reduction. Additional laser annealing in N2 atmosphere leads to a phase transition of the NPs from tenorite to cuprite (Cu2O). Due to the low partial oxygen pressure, the transition is initiated at about 1/3 of the maximum laser power used for the series in air, which is indicated by a drastic increase of the band edge emission from Cu2O. However, annealing with higher laser power leads to strong defect luminescence, which originates from copper and oxygen vacancies. A weak remaining tenorite band edge emission shows an incomplete phase transition.

Type
Articles
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Koffyberg, F.P., and Benko, F.A., Journal of Applied Physics 53(2), 1173 (1982)CrossRefGoogle Scholar
Roos, A., and Karlsson, B., Solar Energy Materials 7, 467 (1983)CrossRefGoogle Scholar
Nuys, M., Flohre, J., Leidinger, C., Köhler, F., and Carius, R., Mat. Res. Soc. Symp. Proc., 1494, (2013)Google Scholar
Rau, U., Phys. Rev. B 76, 085303 (2007)CrossRefGoogle Scholar
O'Keeffe, M., and Moore, W. J., The Journal of Chemical Physics 36(11), 3009 (1962)CrossRefGoogle Scholar
Coughlin, J. R., Bur, U.S.. Mines Bull. 20, 542 (1954)Google Scholar
Chrzanowski, J., and Irwin, J.C., Solid State Communications 70, 11 (1989)CrossRefGoogle Scholar
Xu, J.F., Ji, W., Shen, Z.X., Tang, S.H., Ye, X.R., Jia, D.Z., and Xin, X.Q., Mat. Res. Soc. Symp. Proc. 571, 229 (2000)CrossRefGoogle Scholar
Reydellet, J., Phys. Stat. Sol. (b) 52, 175 (1972)CrossRefGoogle Scholar
Snoke, D.W., Shields, A.J., and Cardona, M., Phys. Rev. B 45, 693 (1992)Google Scholar
Ito, T., and Masumi, T., J. Phys. Soc. Jpn. 66, 2185 (1997)CrossRefGoogle Scholar
Cabannes, J., and Rousset, A., J. Phys. Radium 1(6), 210 (1940)CrossRefGoogle Scholar