Hostname: page-component-cd9895bd7-7cvxr Total loading time: 0 Render date: 2024-12-27T02:06:54.310Z Has data issue: false hasContentIssue false
  • English
  • Français

Characterization and Electrical Properties of WO3 Sensing Thin Films

Published online by Cambridge University Press:  10 February 2011

C. Cantalini ,
S. Di Nardo ,
L. Lozzi ,
M. Passacantando ,
M. Pelino ,
A. R. Phani  and
S. Santucci
C. Cantalini
Affiliation:
Department of Chemistry and Materials - 67040 Monteluco di Roio - L'Aquila - Italy
S. Di Nardo
Affiliation:
Department of Physics - 61010 - L'Aquila - Italy - [email protected]
L. Lozzi
Affiliation:
Department of Physics - 61010 - L'Aquila - Italy - [email protected]
M. Passacantando
Affiliation:
Department of Physics - 61010 - L'Aquila - Italy - [email protected]
M. Pelino
Affiliation:
Department of Chemistry and Materials - 67040 Monteluco di Roio - L'Aquila - Italy
A. R. Phani
Affiliation:
Department of Chemistry and Materials - 67040 Monteluco di Roio - L'Aquila - Italy
S. Santucci
Affiliation:
Department of Physics - 61010 - L'Aquila - Italy - [email protected]
Get access

Abstract

The microstructure and the electrical properties of thermallyevaporated WO3 thin films have been investigated by glancing angle XRD, atomic force microscopy AFM, X-ray photoelectron spectroscopy XPS and dc techniques. Thin films of 1500 Å thickness have been obtained by evaporating high purity WO3 powders by an electricallyheated crucible at 5 × 10−4 Pa on sapphire substrates. Theas-deposited films have resulted to be amorphous. After annealing at 500°C in dry air for 6, 12 and 24 hours the films have shown well crystallized structures with preferential orientations of WO3 in the (200)direction. The increase of the annealing time has shown marked influence onthe microstructural features of the films surface, as highlighted by AFM investigations. The binding energies of W 4f7/2 have been close to that of WO3, the 24 h annealed yielded an O/W ratio close to 2.9 which is in good agreement with the theoretical one. The gas sensitivity, selectivity and stability of the annealed films in presence of NO2 gas (between 0.7 and 5 ppm) have been evaluated by measuring the electrical change of the film resistance in dry air and in gasatmosphere conditions. The influence of NO and Humidity interfering gases to the NO2 electrical response has been also evaluated. The 500 °C annealed at 24 h has shown better electrical properties in terms of NO2 sensitivity, stability and cross sensitivity effects.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 459: Symposium Y – Materials for Smart Systems II , 1996 , 81
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Akiyama, M., Zhang, Z., Tamaki, J., Harada, T., Miura, N. and Yamazoe, N., Tech. Digest 11th Sensor Symp., Japan, 1992. 181 Google Scholar
2. Tamaki, J., Fujii, T., Fujimori, K., Miura, N., Yamazoe, N., Sensors and Actuators B 24–25, 396 (1995)Google Scholar
3. Armelao, L., Bertoncello, R., Granozzi, G., Depaoli, G., Tondello, E. and Battaglin, G., J. Mater. Chem., 4, 407 (1994).Google Scholar
4. Tracy, C. E. and Benson, D.K., J. Vac. Sci. Technol., A 4, 2377 (1986).Google Scholar
5. Smith, D. J., Vetelino, J.F., Falconer, R.S. and Wittman, E.L., Sensors and Actuators B 13–14, 264 (1993).Google Scholar
6. Sberveglieri, G., Depero, L., Groppelli, S. and Nelli, P., Sensors, and Actuators B 26–27, 89 (1995).Google Scholar
7. Cantalini, B., Sun, H.T., Faccio, M., Pelino, M., Santucci, S., Lozzi, L., Passacantando, M., Sensors and Actuators B 31, 81 (1996).Google Scholar
8. Sun, H. T., Cantalini, C., Lozzi, L., Passacantando, M., Santucci, S. and Pelino, M., Microstructural effect on NO2 sensitivity thin film gas sensor, Thin Solid FilmGoogle Scholar
9. Handbook of X-ray Photoelectron Spectroscopy, Chastain, J. (ed.) Perkin Elmer corporation, Minnesota (1992).Google Scholar
10. Frühberger, B., Grunze, M., Dwyer, D.J., Sensors and Actuators B 31, 167 (1996).Google Scholar
11. Yamazoe, N., Sensors and Actuators B 5, 7 (1991).Google Scholar