Hostname: page-component-7bb8b95d7b-2h6rp Total loading time: 0 Render date: 2024-09-12T17:09:29.860Z Has data issue: false hasContentIssue false

Analysis of Fill Factor Losses in a-Si and a-SiGe Alloy Solar Cells Using a New Technique

Published online by Cambridge University Press:  15 February 2011

A. Banerjee
Affiliation:
United Solar Systems Corp., 1100 W. Maple Road, Troy, MI 48084, U.S.A.
X. Xu
Affiliation:
United Solar Systems Corp., 1100 W. Maple Road, Troy, MI 48084, U.S.A.
J. Yang
Affiliation:
United Solar Systems Corp., 1100 W. Maple Road, Troy, MI 48084, U.S.A.
S. Guha
Affiliation:
United Solar Systems Corp., 1100 W. Maple Road, Troy, MI 48084, U.S.A.
Get access

Abstract

A new technique to diagnose fill factor losses occurring in single-junction amorphous silicon (a-Si) alloy based nip solar cells has been explored. The method consists of the measurements of the fill factor of the device under blue and red light illumination and the current-collection loss obtained from the ratio of the quantum efficiency versus wavelength spectra at zero and reverse bias. Normally, the losses are higher at low and high wavelengths. It has been observed that there is a strong correlation between the values of the blue and red fill factors and the current collection losses at the pli interfaces and the bulk of the i-layer, respectively. The losses have been attributed to back diffusion of carriers at the pli interface and to the bulk of the i-Layer. There is a sensitive dependence between these losses and the texture of the substrate: textured substrates lead to higher losses compared to specular substrates. The technique has been used successfully to enhance the values of the red, blue, and AM 1.5 fill factors of both a-Si and amorphous silicon-germanium (a-SiGe) alloy single-junction cells on back reflectors by the optimization of device fabrication parameters. The optimized cells on textured back reflectors exhibit reduced losses. The paper presents an analysis of the experimental results.

Type
Research Article
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Yang, J., Ross, R., Glatfelter, T., Mohr, R., Hammond, G., Bernotaitis, C., Chen, E., Burdick, J., Hopson, M., and Guha, S., Twentieth IEEE Photovoltaic Specialists Conf. Proc., Las Vegas, Nevada (IEEE, New York, 1988) p. 241.Google Scholar
2. Guha, S., Yang, J., Banerjee, A., Glatfelter, T., Hoffman, K., Ovshinsky, S.R., Izu, M., Ovshinsky, H.C., and Deng, X. in Amorphous Silicon Technology, edited by Schiff, E.A., Hack, M., Madan, A., Powell, M., and Matsuda, A. (Mater. Res. Soc. Proc. 336, San Francisco, CA, 1994) pp. 645655.Google Scholar
3. Yang, J., Banerjee, A., Glatfelter, T., Hoffman, K., Xu, X., and Guha, S., 1st World Conf. on Solar Energy Conversion, Hawaii, 1994 (in press).Google Scholar
4. Banerjee, A., Yang, J., Glatfelter, T., Hoffman, K., and Guha, S., Appl. Phys. Lett. 64, 1517 (1994).Google Scholar
5. Banerjee, A., Yang, J., Hoffman, K., and Guha, S., Appl. Phys. Lett. 65, 472 (1994).Google Scholar
6. Banerjee, A., Solar Energy Materials and Solar Cells, 1995 (in press).Google Scholar
7. Banerjee, A., Xu, X., Yang, J., and Guha, S., 1st World Conf. on Solar Energy Conversion, Hawaii, 1994 (in press).Google Scholar
8. Arya, R. R., Catalano, A., and Oswald, R.S., Appl. Phys. Lett. 49, 1089 (1986).Google Scholar
9. Schropp, R.E.I., Ouwens, J.D., Von der Linden, M.B., Van der Werf, C.H.M., Van der Weg, W.F., and Alkemade, P.F.A. in Amorphous Silicon Technology, edited by Schiff, E.A., Thompson, M. J., Madan, A., Tanaka, K., and LeComber, P.G. (Mater. Res. Soc. Proc. 297, San Francisco, CA, 1993) pp. 797802.Google Scholar
10. Xi, J., Liu, T., Iafelice, V., Si, K., and Kampas, F. in Amorphous Silicon Technology, edited by Schiff, E.A., Hack, M., Madan, A., Powell, M., and Matsuda, A. (Mater. Res. Soc. Proc. 336, San Francisco, CA, 1994) pp. 681686.Google Scholar
11. Fantoni, A., Vieira, M., and Martins, R. in Amorphous Silicon Technology, edited by Schiff, E.A., Hack, M., Madan, A., Powell, M., and Matsuda, A. (Mater. Res. Soc. Proc. 336, San Francisco, CA, 1994) pp. 711716.Google Scholar