Published online by Cambridge University Press: 11 February 2011
Epitaxial-transparent-substrate light emitting diodes with a primary emission peak at 590nm and a secondary peak at 560nm have been fabricated in the indium aluminum gallium phosphide (InAlGaP) system. The active layer consists of an undoped, compressively strained indium gallium phosphide (InGaP) quantum well on a transparent In0.22(Al0.2Ga0.8)0.78P/ ∇x[1nx(Al0.2Ga0.8)1-xP] /GaP virtual substrate. Theoretical modeling of this structure predicts an accessible wavelength range of approximately 540nm to 590nm (green to amber). Emission with a peak wavelength of 570nm has been observed via cathodoluminescence studies of undoped structures with a quantum well composition of In0.35Ga0.65P. Light emitting diodes have been fabricated utilizing simple top and bottom contacts. The highest LED power of 0.18μW per facet at 20mA was observed for a quantum well composition of In0.32Ga0.68P and a bulk threading dislocation density on the order of 7×106 cm-2. The spectrum of this device was composed of two peaks: a weak peak at the predicted 560nm wavelength and a stronger peak at 590nm. Based upon superspots present in electron diffraction from the quantum well region, we believe that the observed spectrum is the result of emission from ordered and disordered domains in the active region. The same device structure grown with a bulk threading dislocation density on the order of 5×107 cm-2 exhibited an identical spectral shape with a reduced power of 0.08μW per facet at 20mA. For a quantum well composition of In0.37Ga0.63P and an overall threading dislocation density on the order of 5×107 cm-2, a single peak wavelength of 588nm with a power of 0.06μW per facet at 20mA was observed.