Hostname: page-component-78c5997874-j824f Total loading time: 0 Render date: 2024-11-19T23:58:01.276Z Has data issue: false hasContentIssue false
  • English
  • Français

Waterproof coating on nonlinear optical crystal surfaces by photo–oxidation of silicone oil

Published online by Cambridge University Press:  01 February 2011

Nobuhiro Sato ,
Yuji Sato ,
Yoshiaki Okamoto  and
Masataka Murahara
Nobuhiro Sato
Affiliation:
[email protected], Tokai University, Electrical Engineering, 1117 Kitakaname, Hiratsuka-shi, Kanagawa, N/A, 259-1292, Japan, 81-463-58-1211, 81-463-59-4014
Yuji Sato
Affiliation:
[email protected], Tokyo Institute of Technology, Entropia Laser Initiative, Japan
Yoshiaki Okamoto
Affiliation:
[email protected], Okamoto Optics Co., Japan
Masataka Murahara
Affiliation:
[email protected], Tokyo Institute of Technology, Entropia Laser Initiative, Japan
Get access

Abstract

Organic silicone oil was photo–chemically oxidized to change into SiO2 by using a ultraviolet (UV) excimer lamp, which developed an over–coating for a nonlinear optical crystal.

In general, nonlinear optical crystals are used as a wavelength conversion element for laser. The crystals are, however, deliquescent and absorb moisture in the air, which causes clouding. They need heating in the oven to prevent it. It is desired to develop a protective film on the nonlinear optical crystals so as to be waterproof and transmit UV rays. We have, then, developed the waterproof and protective film on a KH2PO4 (KDP) surface, which was photo–chemically oxidized by using a silicone oil and Xe2 excimer lamp. The silicone oil was spin–coated on the KDP crystal surface, and then the Xe2 excimer lamp was vertically irradiated to the crystal surface. The O atoms in the air were photo–excited with the UV photon to generate high active O atoms. At the same time, the C—H and the Si—C bonds of the silicone oil were photo–dissociated because the photon energy of the UV photon is higher than the bonding energies of the C—H and Si—C. The siloxane of the silicone oil was consequently linked with the O2 that had been absorbed on the crystal surface to form SiOn. As a result, the SiO2 film was formed on the KDP crystal surface by the photo–oxidation of silicone oil.

The infrared spectroscopy analysis (ATR-FTIR) was carried out to investigate the modified film. The results showed that as the time of lamp irradiation extended, the absorption peak of the —CH3 groups at 2900 cm−1 decreased, but the absorption peak of the —SiO groups at 1050cm−1 increased. At the lamp irradiation time of 90 minutes, the UV transmittance of the treated silicone oil improved to 88.9 % at the 260 nm, which is the wavelength of the fourth harmonic generation, while that of the untreated silicone oil was 56 %.

The treated and untreated KDP crystals were tested for their waterproofing. The untreated crystal was completely dissolved thirty minutes after soaking in the water, and on the contrary, the KDP crystal with the film coating has neither been dissolved nor gotten cloudy for three months when soaking in water.

Keywords

coatingcrystalphotochemical
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 890: Symposium Y – Surface Engineering for Manufacturing Applications , 2005 , 0890-Y08-08
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCE

1. Mahajan, A.M., Patil, L.S., Bange, J.P., and Gautam, D.K., Vacuum, Vol. 79, pp194–202 (2005)Google Scholar
2. Dennler, G., Houdayer, A., Raynaud, P., Seguy, I., Seguy, Y., and Wertheimer, M.R., Nuclear Instruments and Methods in Physics Research B, Vol. 208, pp176–180 (2003)Google Scholar
3. Orlowski, T.E. and Richter, H., Applied Physics Letter, Vol. 45, No.3, pp1 (1984)Google Scholar
4. Awazu, K., Journal of Non-Crystalline Solids, Vol.337, pp241–253 (2004)Google Scholar
5. Hozumi, A., Masuda, T., Sugimura, H. and Kameyama, T., Langmuir, Vol.19, pp7573–7579 (2003)Google Scholar
6. Hozumi, A., Masuda, T., Hayashi, K., Sugiyama, H., Takai, O., and Kameyama, T., Langmuir, Vol.18, pp9022–9027 (2002)Google Scholar
7. Yokotani, A., Takezoe, N., and Kurosawa, K., Applied Physics Letter, Vol.69, No.10, pp2 (1996)Google Scholar
8. Takezoe, N., Yokotani, A., Kurosawa, K., Sasaki, W., Igarashi, T., and Masuno, H., Applied Surface Science, Vol. 138–139, pp340–343 (1999)Google Scholar
9. Boyer, P.K., Roche, G.A., Ritchie, W.H., and Collins, G.J., Applied Physics Letter, Vol.40, No.8, pp15 (1982)Google Scholar
10. Awazu, K. and Onuki, H., Applied Physics Letter, Vol.69, No.4, pp22 (1996)Google Scholar
11. Murahara, M., Ogawa, Y., Yoshida, K., and Okamoto, Y., Proc. SPIE, 4932, 48 (2003)Google Scholar
12. Murahara, M., Journal of the JSTP, Vol.27, No.307, pp934–942 (1986–1988) in JapaneseGoogle Scholar