Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-16T20:19:34.757Z Has data issue: false hasContentIssue false

Top-gate ZnO-based TFTs by RF Sputtering

Published online by Cambridge University Press:  01 February 2011

Shahrukh Khan
Affiliation:
[email protected], Lehigh University, Electrical Engineering, 16 A, Memorial Drive East, Sherman Fairchild Center of Solid State Studies, Bethlehem, PA, 18015, United States
Abbas jamshidi-Roudbari
Affiliation:
[email protected], Lehigh University, Department of Electrical Engineering, Bethlehem, PA, 18015, United States
Miltiadis Hatalis
Affiliation:
[email protected], Lehigh University, Department of Electrical Engineering, Bethlehem, PA, 18015, United States
Get access

Abstract

This work emphasizes room temperature deposition and fabrication of top-gated staggered structure ZnO-TFTs and integration of ZnO-TFT based simple logic circuits. We synthesized ZnO thin films by RF sputtering in an Ar/Oxygen ambience with no intentional heating of the substrates. The electrical, optical and structural properties of the ZnO thin films can be well-controlled by altering process parameters such as RF power density and relative Oxygen partial pressure. Typical deposition was carried out at a chamber pressure of 15 mTorr, Ar/Oxygen flow rates of 15 sccm/1 sccm and RF power density of 3W/cm2. The resistivity of the as-deposited films was between 104-106 Ù-cm with high optical transparency (>80%) in the visible spectrum and minimal surface roughness as detected by high-resolution AFM imaging. Gated van der Pauw and Kelvin-bridge structures were lithographically patterned to asses ZnO channel resistance. In the completed devices, a dual-stack (Ta2O5/SiO2) dielectric layer was effective in suppressing gate-leakage current below 10 pA and enabled depletion-mode ZnO-TFT operation exhibiting hard saturation. A Ti/Au metallization scheme was adopted to provide good ohmic contact to ZnO. TFTs retained well-behaved transfer characteristics down to a channel length of 4 ìm with on/off drain current ratio exceeding 105, threshold voltage between -15 V to -5 V and inverse sub-threshold slope of around 1.75 V/decade.

Type
Research Article
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. He, Y., Hattori, R., and Kanicki, J., IEEE Electron Devices Letters, 21, 590592 (2000)10.1109/55.887475Google Scholar
2. Kwon, Y. et al. , Appl. Phys. Lett, 84, 2685–2657 (2004)Google Scholar
3. Thomas, M.E., Holloway, M.P. and Mckay, J. E., J. Vac. Sci. Technol, A6, 2570 (1988)10.1116/1.575550Google Scholar
4. Swalin, R.A., Thermodynamics of Solids (Wiley, New York, 1972) p 335 Google Scholar
5. Oh, M.S., Hwang, D.K., Lee, K., Im, S., Yi, S., Appl. Phys. Lett, 90, 17351 (2007)Google Scholar