Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-29T07:39:09.298Z Has data issue: false hasContentIssue false
  • English
  • Français

Thermal Shock Behaviour of Thin Bi-Material Ceramic Systems

Published online by Cambridge University Press:  10 February 2011

E. P. Busso ,
Y. V. Tkach  and
R. P. Travis
E. P. Busso
Affiliation:
Mechanical Engineering Department, Imperial College, London SW7 2BX, United Kingdom
Y. V. Tkach
Affiliation:
Mechanical Engineering Department, Imperial College, London SW7 2BX, United Kingdom
R. P. Travis
Affiliation:
Mechanical Engineering Department, Imperial College, London SW7 2BX, United Kingdom
Get access

Abstract

This work describes a methodology developed to predict the thermal shock behaviour of thin bi-material ceramic systems. An experimental procedure based on controlled air cooling has been devised to simulate the flow of a gas stream over the surface of a thin two-layer ceramic system. Results of microstructural and fractographic investigations conducted on tested samples, including representative fracture patterns and crack initiation sites, are presented. A probabilistic-deterministic approach to predict the thermal shock behaviour of bi-material ceramic systems is proposed. Failure diagrams are constructed from a combination of the experimental and analytical studies. Critical thermal transient conditions typical of start-up and shut-down operation in solid oxide fuel cell are determined.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 594: Symposium V – Thin Films - Stresses & Mechanical Properties VIII , 1999 , 31
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Hutchinson, J.W. and Evans, A.G.. Acta Metall Mater, 43, p. 2507 (1995).Google Scholar
2. Busso, E.P., Tkach, Y.V. and Travis, R.P.. Submitted for publication. (1999).Google Scholar
3. Chandra, L., Busso, E.P., and Travis, R.P.. Submitted for publication (1999).Google Scholar
4. Wachtman, J.B.. Mechanical Properties of Ceramics, Wilay-Interscience (publ.) (1996).Google Scholar
5. Hodulak, L. L., Blauei, J.G., Siegele, D. and Urich, B.. Nuclear Eng. Design, 188, p. 139, (1999).Google Scholar