Hostname: page-component-78c5997874-8bhkd Total loading time: 0 Render date: 2024-11-16T15:03:00.791Z Has data issue: false hasContentIssue false
  • English
  • Français

The Slope Etching of a-Si:H Film using CF4 + O2 Gas

Published online by Cambridge University Press:  21 February 2011

Kang Hyun Sung ,
B. W. Park ,
J. J. Kim ,
C. Y. Kim ,
J. I. Choi ,
H. K. Bae ,
Y. H. Park  and
C. W. Hur
Kang Hyun Sung
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
B. W. Park
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
J. J. Kim
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
C. Y. Kim
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
J. I. Choi
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
H. K. Bae
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
Y. H. Park
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
C. W. Hur
Affiliation:
GoldStar Central Research Laboratory, Seoul, Korea.
Get access

Abstract

The slope etching technology of hydrogenated amorphous silicon film (a-Si:H) has been very useful for its devices; thin film transistor, contact image sensor and other large area electronic components. To obtain a good step coverage slope etching was performed by RIE using CF4 gas and optimum amount of O2 gas after modification of photoresist(PR) patterns by thermal treatment. In this experiment, primary factors were

1) thermal treatment temperature and time of PR.

2) CF4 gas flow rate, etch rate of a-Si:H film and ash rate of PR in proportion to O2 gas flow rate.

As a result, the slope angle of 11° was obtained when CF4 gas flow rate was 46 SCCM, O2 gas flow rate was 7 SCCM and thermal treatment temperature and time was 140°C and 30 minutes respectively.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 219: Symposium A – Amorphous Silicon Technology - 1991 , 1991 , 811
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Hamakawa, Y., “Dry Etching Processing”. Amorphous Semiconductor Technologies and Device, vol. 16 (1984).Google Scholar
[2] Mogab, C.J., J. Electrochem. Soc, vol. 124. No. 8, 1262 (1977)Google Scholar
[3] Melliar-Smith, C.M. and Mogab, C.J., “Plasma-Assisted Etching Techniques for Pattern Delineation.”, in Vossen, J.L. and Kern, W., Eds., Thin Film Process Academic, New York (1979).Google Scholar
[4] Adams, A.C., Solid State Technol., 26(4), 135 (1984).Google Scholar
[5] Kishida, S., Naruke, Y., Uchda, Y. and Matsumura, M., Jpn. J. Appl. Phys., 22, 511 (1983).CrossRefGoogle Scholar
[6] Maeda, M. and Nakamura, H., Thin Solid Films 112, 279 (1984).Google Scholar