Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-25T16:35:47.150Z Has data issue: false hasContentIssue false
  • English
  • Français

Residual Stress in Diamond and Amorphous Carbon Films

Published online by Cambridge University Press:  15 February 2011

Joel W. Ager
Joel W. Ager*
Affiliation:
Center for Advanced Materials, Materials Sciences Division, Lawrence Berkeley Laboratory, Berkeley, CA 94720
Get access

Abstract

Both diamond and amorphous carbon films can contain substantial residual stresses (up to 10 GPa and higher) due to a combination of thermal and intrinsic effects. Residual stresses in the films limit the maximum thickness to which films can be grown and can lead to weakening and/or failure of the film/substrate interface. In addition, a quantitative measurement of the residual stress in the film is required for an accurate determination of the film/substrate interface fracture toughness. Spectroscopic measurements of residual stresses in diamond and amorphous carbon films based on frequency shifts of Raman-active phonon modes are presented. The spatial resolution of the technique is 1 μm in the lateral direction. In transparent materials such as single crystal diamond, stress profiles with 10 μm resolution in the axial direction can be measured. Examples of such stress profiles are presented for natural and CVD-grown single crystals. Raman measurements of thermal stress in thin polycrystalline diamond films on metal substrates are presented. Initial, spatially resolved measurements of large, compressive intrinsic growth stresses in high-hardness amorphous carbon films grown by ion beam techniques are presented. The accuracy of the Raman residual stress measurement depends on the film structure and is ±60 MPa for single crystal diamond, ±120 MPa for polycrystalline diamond, and ±500 MPa for hard amorphous carbon.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 383: Symposium I – Mechanical Behavior of Diamond and Other Forms of Carbon , 1995 , 143
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Drory, M. D. and Hutchinson, J. W., Science 263, 1753 (1994); M. D. Drory and J. W. Hutchinson, this volume.Google Scholar
2. Nix, W. D., Vlassak, J. J., Holdfelder, R. J., and Sizemore, J. T., this volume.Google Scholar
3. Landstrass, M. I., Plano, M. A., Moreno, M. A., McWilliams, S., Pan, L. S., Kania, D. R., and Han, S., in Proceedings of Diamond Films ‘92/ICNDST-3. Google Scholar
4. IIIAger, J. W. and Drory, M. D., Phys. Rev. B 48, 2601 (1993).Google Scholar
5. Perry, S. S., IIIAger, J. W., Somorjai, G. A., McClelland, R. J., and Drory, M. D., J. Appl. Phys. 74, 7542 (1994).Google Scholar
6. Anders, S., Anders, A., Brown, I. G., Wei, B., Komvopoulos, K., IIIAger, J. W., and Yu, K. M., Surf. Coatings Technol. 68/69, 388 (1994).Google Scholar
7. IIIAger, J. W., Anders, S., Anders, A., Brown, I. G., Appl. Phys. Lett., in press.Google Scholar
8. Pharr, G. M., Callahan, D. L., McAdams, S. D., Tsui, T. Y., Anders, S., Anders, A., IIIAger, J. W., Brown, I. G., Bhatia, C. S., Silva, S. R. P., and Roberton, J., Appl. Phys. Lett., submitted.Google Scholar
9. Grimsditch, M. H., Anastassakis, E., and Cardona, M., Phys. Rev. B 18, 901 (1978).Google Scholar
10. Boppart, H., van Straaten, J., and Silvera, I. F., Phys. Rev. B 32, 1423 (1985).Google Scholar
11. Hanfland, M., Syassen, K., Fahy, S., Louie, S. G., and Cohen, M. L., Physica 139/140B, 516 (1986).Google Scholar
12. Sakata, H., Dresselhaus, G., Dresselhaus, M. S., and Endo, M., J. Appl. Phys. 63, 2769 (1988).Google Scholar
13. Dresselhaus, M. S., Dresselhaus, G., Sugihara, K., Spain, I. L., and Goldberg, H. A., Graphite Fibers and Filaments, (Springer Verlag, Heidelberg, 1988), pp. 85–95, 120–123.Google Scholar
14. Van Enckevort, W. J. P., “Physical, Chemical, and Microstructural Characterization and Properties of Diamond, in Synthetic Diamond, ed. Spear, K. E. and Dismukes, J. P., (Wiley, New York, 1994) pp. 307–353.Google Scholar
15. Plano, M. A., Moyer, M. D., Moreno, M. A., Black, D., Burdette, H., IIIAger, J. W., and Chen, A. L., presented at the 1995 Spring Electrochemistry Society Meeting (unpublished).Google Scholar