Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-06T00:24:24.652Z Has data issue: false hasContentIssue false
  • English
  • Français

Principal Residual Strains as A function of Depth for Sputter Deposited Mo Thin Films

Published online by Cambridge University Press:  21 February 2011

S. G. Malhotra ,
Z. U. Rek ,
L. J. Parfitt ,
S. M. Yalisove  and
J. C. Bilello
S. G. Malhotra
Affiliation:
University of Michigan, Department of Materials Science and Eng., Ann Arbor, MI 48109-2136
Z. U. Rek
Affiliation:
Stanford Synchrotron Radiation Laboratory, Stanford, CA 94305
L. J. Parfitt
Affiliation:
University of Michigan, Department of Materials Science and Eng., Ann Arbor, MI 48109-2136
S. M. Yalisove
Affiliation:
University of Michigan, Department of Materials Science and Eng., Ann Arbor, MI 48109-2136
J. C. Bilello
Affiliation:
University of Michigan, Department of Materials Science and Eng., Ann Arbor, MI 48109-2136
Get access

Abstract

Traditionally, the magnitude of the stress in a thin film is obtained by measuring the curvature of the film-substrate couple; however, these techniques all measure the average stress throughout the film thickness. On a microscopic level, the details of the strain distribution as a function of depth through the thickness of the film can have important consequences in governing film quality and ultimate morphology. A new method for determining the magnitude of principal strains (strain eigenvalues) as a function of x-ray penetration depth using grazing incidence x-ray scattering for a polycrystalline thin film will be described. Results are reported for two Mo metallizations ˜ 500 Å and ˜1000 Å thick sputtered onto Si {100} substrates. The magnitude of the principal strains at several penetration depths was accomplished by an analysis of the diffraction peak shifts of at least six independent {hkl} scattering vectors from the Mo thin films. An out-of-plane strain gradient was identified in both Mo films and the strain eigenvalues were found to be anisotropic in nature. This new methodology should work with a variety of thin films and hence would provide quantitative insight into the evolution of thin film microstructure.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 356: Symposium B2 – Thin Films: Stresses and Mechanical Properties V , 1994 , 603
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Floro, J.A., Thompson, C.V., Carel, R., and Bristowe, P.D., J. Mater. Res. 9, 2411 (1994)Google Scholar
2. Windischmann, H., Critical Reviews in Solid State and Materials Sciences 17,547 (1992).Google Scholar
3. Movchan, B.A. and Demchishin, A.V., Fizika Metall. 28, 83 (1969).Google Scholar
4. Thornton, J.A., Ann. Rev. Mater. Sci. 7, 239 (1977).Google Scholar
5. Dosch, H., Phys. Rev. B. 35, 2137 (1987).Google Scholar
6. Venkatraman, R., Besser, P.R., Bravman, J.C., and Brennan, S., J. Mater. Res. 9, 328 (1994).Google Scholar
7. Besser, P.R., Brennan, S., Bravman, J.C., J. Mater. Res. 9, 13 (1994).Google Scholar
8. Shute, C.J. and Cohen, J.B., J. Appl. Phys. 70, 2104 (1991).Google Scholar
9. Martinez-Miranda, L.J., Santiago-Aviles, J.J., Graham, W.R., Heiney, P.A., Siegal, M.P., and J. Mater. Res. 9, 1434 (1994).Google Scholar
10. Doerner, M.F. and Brennan, S., J. Appl. Phys. 63, 126, (1988).Google Scholar
11. Fisher, R.M., Duan, J.Z., and Fox, A.G., in Thin Films: Stresses and Mechanical Properties. (Mat. Res. Symp. Proc. 130, Pittsburgh, PA, 1989) p. 249.Google Scholar
12. Hoffman, R.W., Surf, and Int. Analy. 3, 62 (1981).Google Scholar
13. Vink, T.J., Somers, M.A.J., Daams, J.L.C., and Dirks, A.G., J. Appl. Phys. 70, 4301 (1991).Google Scholar
14. Beers, Y., Introduction to the Theory of Error, 3rd ed. (Addison-Wesley Publishing Company, 1962), p. 28.Google Scholar
15. Imura, T., Weissmann, S., and Slade, J.J. Jr., Acta. Cryst. 15, 786 (1962).Google Scholar
16. Nye, J.F., Physical Properties of Crystals (Oxford University Press, 1985), p. 41.Google Scholar
17. Deiter, G.E., Mechanical Metallurgy (McGraw-Hill Book Company, Inc., 1961), p.39.Google Scholar
18. Tao, J., Lee, L.H., and Bilello, J.C., J. Elect. Mat. 20, 819 (1991).Google Scholar
19. Stoney, G.G., Proc. Roy. Soc. Ser A82, 172 (1909).Google Scholar
20. Hoffman, D.W., in Phvsics of Thin Films, eds. Haas, G. and Thun, R.E., 3, 211 (1965).Google Scholar