Hostname: page-component-78c5997874-lj6df Total loading time: 0 Render date: 2024-11-19T23:57:48.926Z Has data issue: false hasContentIssue false
  • English
  • Français

On the High Temperature Behavior of Niobium Aluminide intermetallics

Published online by Cambridge University Press:  26 February 2011

A. B. Rodriguez ,
E. P. Barth  and
J. K. Tien
A. B. Rodriguez
Affiliation:
The University of Texas at Austin, Strategic Materials Research and Development Laboratory, Austin, TX.
E. P. Barth
Affiliation:
The University of Texas at Austin, Strategic Materials Research and Development Laboratory, Austin, TX.
J. K. Tien
Affiliation:
The University of Texas at Austin, Strategic Materials Research and Development Laboratory, Austin, TX.
Get access

Abstract

A basic characterization of the mechanical and physical properties of a Niobium Aluminide intermetallic, NbAl3 , was undertaken. Four ingots of material were vacuum arc-melted, yielding a two phase microstructure in each case. Physical testing including coefficient of thermal expansion measurement was performed on the most promising ingot. Elastic modulus of this compound was measured in compression. Elevated temperature microindentation measurements have been performed to gain insight into the deformation behavior as a function of temperature. Microindentation measurements have also been used to study the time-dependent deformation of NbAl3.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 213: Symposium Q – High-Temperature Ordered Intermetallic Alloys IV , 1990 , 539
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Jung, I., Rudy, M., and Sauthoff, G., in High Temperature Ordered Intermetallics II. eds., Stoloff, N.S., Koch, C.C., Liu, C.T., Izumi, O., (Mater. Res. Soc. Proc. 81, Boston, MA 1988) p. 263..Google Scholar
2. Subramanian, P.R., et al. , in High Temperature Ordered Intermetallics III eds., Liu, C.T., Taub, A.I., Stoloff, N.S., Koch, C.C., (Mater. Res. Soc. Proc. 133, Boston, MA 1988) p. 51.Google Scholar
3. Schectman, D., Jacobson, L.A., Met. Trans. A, 6A, 1325 (1975).Google Scholar
4. Vignoul, G.E., Sanchez, J.M. and Tien, J.K., to be presented at the 1990 MRS Fall Meeting, Boston MA, 1990.Google Scholar
5. Takeyama, M. and Liu, C.T., J. Mater. Res., 5, 1189 (1990).CrossRefGoogle Scholar
6. Atkins, A.G., Silverio, A., and Tabor, D., J. of the Institute of Metals, 94, 369 (1966).Google Scholar
7. Anton, D.L., Shah, D.M., in High Temperature Ordered Intermetallics III eds., Liu, C.T., Taub, A.I., Stoloff, N.S., Koch, C.C., (Mater. Res. Soc. Proc. 133, Boston, MA 1988) p. 361.Google Scholar