Hostname: page-component-78c5997874-lj6df Total loading time: 0 Render date: 2024-11-06T11:59:35.070Z Has data issue: false hasContentIssue false

New Resistive Switching Phenomena in Devices with Limited Active Metal Source

Published online by Cambridge University Press:  09 May 2013

Mohini Verma
Affiliation:
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, U.S.A.
Yuhong Kang
Affiliation:
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, U.S.A.
Tanmay Potnis
Affiliation:
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, U.S.A.
Sushil Khadka
Affiliation:
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, U.S.A.
Tong Liu
Affiliation:
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, U.S.A.
Marius Orlowski
Affiliation:
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, U.S.A.
Get access

Abstract

To better understand the mechanisms of creation and rupture of conductive filaments in resistive switching devices such as Cu/TaOx/Pt, with Cu and Pt being the active and inert electrodes, respectively, a device with limited supply of active metal electrode has been manufactured and electrically characterized. The limited supply of active metal has been realized by depositing a thin (delta) Cu layer (δ-Cu), 6 nm and 12 nm thick, on TaOx, resulting in a Pt/δ-Cu/TaOx/Pt device structure. The limited active metal supply i) has a direct impact on the onresistance (Ron) of the Cu bridge, and leads, after several conventional set-reset cycles, to ii) pulsating behavior, when device turns on and off repeatedly, to iii) symmetric switching behavior with respect to applied voltage polarity, when the device can be set and reset both at positive and negative bias, and to iv) volatile switching behavior.

Type
Articles
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Banno, N., Sakamoto, T., Iguchi, N., Kawaura, H., Kaeriyama, S., Mizuno, M., Terabe, K., Hasegawa, T., Aono, M., IEICE Trans. Electron., vol. 869, p. 1492–98 (2006)CrossRefGoogle Scholar
Sawa, A., Materials Today, vol. 11, p.2836(2008)CrossRefGoogle Scholar
Valov, I., et al. Nanotechnology 22(25) pp. 4003–25 (2011)CrossRefGoogle Scholar
Waser, R., and Valov, I., ECS Trans., 25(6) 431437 (2009)CrossRefGoogle Scholar
Linn, E., Rosezin, R., Kugeler, C., and Waser, R., Nat. Mater. 9, 403 (2010)CrossRefGoogle Scholar
Sakamoto, T., Banno, N., Iguchi, N., Kawaura, H., Sunamura, H., Fujieda, S., Terabe, K., Hasegawa, T., and Aono, M., “A Ta2O5 solid-electrolyte switch with improved reliability, ” in VLSI Symp. Tech. Dig., 2007, pp. 3839.Google Scholar
Banno, N., Sakamoto, T., Iguchi, N., Sunamura, H., Terabe, K., Hasegawa, T., and Aono, M., IEEE Trans. Electron Devices, vol. 55, no. 11, pp. 32833287, Nov. 2008.CrossRefGoogle Scholar
Liu, T., Verma, M., Kang, Y., and Orlowski, M., ECS Sol. State Lett. 1(1), p.Q11 (2012)CrossRefGoogle Scholar
Liu, T., Verma, M., Kang, Y., amd Orlowski, M., Appl. Phys. Lett. 101, p. 073510 (2012)CrossRefGoogle Scholar
Kang, Y., Verma, M., Liu, T., and Orlowski, M., ECS Sol. State Lett. 1(5), p.Q48 (2012)CrossRefGoogle Scholar
Liu, T., Kang, Y., El-Helw, S., Potnis, T., and Orlowski, M., “ Radial Growth Model for Conical Nanobridge in Resistive Switching Memory Devices” paper accepted to this conference Google Scholar