Hostname: page-component-78c5997874-fbnjt Total loading time: 0 Render date: 2024-11-06T09:57:05.727Z Has data issue: false hasContentIssue false

A Model for Calculating Substrate Curvature During Coalescence of PT Islands on an Amorphous Substrate

Published online by Cambridge University Press:  10 February 2011

M. A. Phillips
Affiliation:
Department of Materials Science & Engineering, Stanford University, Stanford CA 94305
V. Ramaswamy
Affiliation:
Department of Materials Science & Engineering, Stanford University, Stanford CA 94305
B. M. Clemens
Affiliation:
Department of Materials Science & Engineering, Stanford University, Stanford CA 94305
W. D. Nix
Affiliation:
Department of Materials Science & Engineering, Stanford University, Stanford CA 94305
Get access

Abstract

Previous work using in-situ curvature measurement has shown a correlation between stress and microstructure during the early stages of thin film growth. The model presented here can be used to predict the curvature change of the substrate during part of this growth process. Curvature, and thus film stress, is measured in-situ during growth of sputter-deposited Pt on amorphous substrates. The average film stress is observed to be slightly compressive initially, followed by a change towards a tensile maximum, after which the stress becomes compressive again. Plan view TEM micrographs of Pt films of thicknesses up to 35 Å show the evolution of microstructure from isolated islands to a coalesced film. This evidence suggests that the tensile regime is due to island coalescence. The model calculates the curvature induced in a substrate during the tensile excursion associated with island coalescence, where discontinuous islands are modeled as a series of cracks in an otherwise continuous film. Quantitative measurements of island size and areal fraction covered are extracted from the TEM micrographs and used to predict the curvature during coalescence. The predicted stresses are shown to compare favorably with the measured stresses.

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Abermann, R. and Koch, R., Thin Solid Films 129, 71–8 (1985).Google Scholar
2 Nix, W. D. and Clemens, B. M., Journal of Materials Research 14, 34673473 (1999).Google Scholar
3 Abermann, R., Kramer, R., and Maser, J., Thin Solid Films 52, 215–29 (1978).Google Scholar
4 Hutchinson, J. W., Harvard University, (private communication).Google Scholar
5 Ramaswamy, V., Clemens, B. M., and Nix, W. D., (Mater. Res. Soc. Proc. 528, San Francisco, CA, 1998), pp. 161–8Google Scholar
6 Beuth, J. L. Jr., International Journal of Solids and Structures 29, 1657–75 (1992).Google Scholar