Published online by Cambridge University Press: 28 July 2011
SrTa2O6 thin films with thickness between 6 and 150nm were deposited in a multi-wafer planetary MOCVD reactor combined with a TRIJET® liquid delivery system using a single source precursor, strontium-tantalum-(methoxyethoxy)-ethoxide dissolved in toluene. A rather narrow process window for the deposition of stoichiometric SrTa2O6 was found for this precursor at low pressures and a susceptor temperature around 500°C. Films were grown on Pt/TiO2/SiO2/Si, TiNx/Si, and SiO2/Si substrates. The as-deposited films were X-ray amorphous and could be crystallized by post-annealing at a temperature ≥700°C. The SrTa2O6 phase was dominating within a broad range of compositions (Sr/Ta: 0.4–0.7) and a perovskite type phase was observed for Sr/Ta > 0.7. The electrical properties have been investigated with MIM and MIS capacitors after sputter deposition of Pt top electrodes. The amorphous films had a relative permittivity, ε, in the range of 25–45, and low leakage currents. Crystallized films were investigated with Pt MIM capacitors. For stoichiometric SrTa2O6 the dielectric permittivity reached values of ε = 100–110, but the leakage currents were increased. Remarkably, the permittivity is not very sensitive to deviations from the exact stoichiometry of the SrTa2O6 phase (Sr/Ta: 0.40.7), but a decrease to values of ε = 30–40 is observed along with the phase transition at high Sr contents.