Article contents
Microstructures of Y123 Films on Srtio3, Lagao3 and Laaio3
Published online by Cambridge University Press: 28 February 2011
Abstract
Transmission electron microscopy(TEM) and scanning electron microscopy (SEM) have been used to study the microstructural features of YBa2Cu3O7 (hereafter referred to as Y123) films grown on various single crystal substrates by electron beam deposition. The films are all of high quality with the best observed Jc value being 10 A.cm‐2 at 7K. Cross‐sectional views in TEM have shown that the morphology of the film depends on its thickness. Thinner films (2500 Å) have a single layer of Y123 oriented with its c‐axis perpendicular to the substrate while thicker films(8000 Å) have this same c‐axis perpendicular layer closest to the interface with a c‐axis parallel layer above it. The interface between the film and the substrate is well defined in all cases with no amorphous region at the interface. Chemical analysis shows evidence of interdiffusion between the film and substrate.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 1990
References
- 2
- Cited by