Hostname: page-component-cd9895bd7-dzt6s Total loading time: 0 Render date: 2024-12-27T01:51:06.693Z Has data issue: false hasContentIssue false
  • English
  • Français

Luminous efficiency of AC Plasma Display Panels with MgO–TiO2

Published online by Cambridge University Press:  21 March 2011

Younghyun Kim ,
Rakhwan Kim ,
Yonguk Lee ,
Seonghoon Jung  and
Jong-Wan Park
Younghyun Kim
Affiliation:
Div. of Material Science and Engineering, Hanyang University, Seoul 133-791, Korea
Rakhwan Kim
Affiliation:
Div. of Material Science and Engineering, Hanyang University, Seoul 133-791, Korea
Yonguk Lee
Affiliation:
Div. of Material Science and Engineering, Hanyang University, Seoul 133-791, Korea
Seonghoon Jung
Affiliation:
Div. of Material Science and Engineering, Hanyang University, Seoul 133-791, Korea
Jong-Wan Park
Affiliation:
Div. of Material Science and Engineering, Hanyang University, Seoul 133-791, Korea
Get access

Abstract

In order to improve both the operating voltage and the luminous efficiency of the protective layer for AC Plasma Display Panels, controlled amount of TiO2 was added to the pure MgO. The effect of the TiO2 addition on both the electrical properties (firing voltage & sustain voltage) and the luminous efficiency of the Mg2−2xTixO2 films deposited by e-beam evaporation was investigated. By addition of a proper amount of TiO2 to MgO, the dielectric constant of protective layer was increased to the 11, which has higher than that of bulk MgO. When the composition of Ti in the thin films was about 2.45at%, firing and sustain voltages were very low. With this composition, the luminous efficiency characteristics were much better than that of any other protective layer. When compared to that of the conventional MgO protective layer, the luminous efficiency showed an increase by 28%.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 672: Symposium O – Mechanisms of Surface and Microstructure Evolution in Deposited Films and Film Structures , 2001 , O8.27
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Mikoshiba, S., Society for Information Display. 15 (2/1999) 28 Google Scholar
2. Kim, R., Kim, Y., Park, J.-W., Thin Solid Films. 376(2000)183 Google Scholar
3. McCaughan, Daniel V., Kushner, R. A., and Murphy, V. T., Phys. Rev. Lett. Vol. 30, No. 13 (1973) 614 Google Scholar
4. Lee, S.Y., Park, J.W., J.Appl. Phys., 80(1996) 5260.Google Scholar
5. Shiokawa, A., Takada, Y., Murai, R. and Tanaka, H., in the Proceedings of International Display Workshops 98, (1998) 519.Google Scholar