Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-20T07:01:36.608Z Has data issue: false hasContentIssue false
  • English
  • Français

Local Microstructure and Stress in Al(Cu) Thin Film Structures Studied by X-Ray Microdiffraction

Published online by Cambridge University Press:  18 March 2011

B.C. Valek ,
N. Tamura ,
R. Spolenak ,
A.A. MacDowell ,
R.S. Celestre ,
H.A. Padmore ,
J.C. Bravman ,
W.L. Brown ,
B. W. Batterman  and
J. R. Patel
B.C. Valek
Affiliation:
Dept. Materials Science & Engineering, Stanford University, Stanford CA 94305, USA
N. Tamura
Affiliation:
ALS/ LBNL, 1 Cyclotron Road, Berkeley CA 94720, USA
R. Spolenak
Affiliation:
Agere Systems, formerly of Bell Laboratories, Lucent Technologies, Murray Hill NJ 07974, USA
A.A. MacDowell
Affiliation:
ALS/ LBNL, 1 Cyclotron Road, Berkeley CA 94720, USA
R.S. Celestre
Affiliation:
ALS/ LBNL, 1 Cyclotron Road, Berkeley CA 94720, USA
H.A. Padmore
Affiliation:
ALS/ LBNL, 1 Cyclotron Road, Berkeley CA 94720, USA
J.C. Bravman
Affiliation:
Dept. Materials Science & Engineering, Stanford University, Stanford CA 94305, USA
W.L. Brown
Affiliation:
Agere Systems, formerly of Bell Laboratories, Lucent Technologies, Murray Hill NJ 07974, USA
B. W. Batterman
Affiliation:
ALS/ LBNL, 1 Cyclotron Road, Berkeley CA 94720, USA SSRL/SLAC, Stanford University, P.O.BOX 43459, Stanford CA 94309, USA
J. R. Patel
Affiliation:
ALS/ LBNL, 1 Cyclotron Road, Berkeley CA 94720, USA SSRL/SLAC, Stanford University, P.O.BOX 43459, Stanford CA 94309, USA
Get access

Abstract

The microstructure of materials (grain orientation, grain boundaries, grain size distribution, local strain/stress gradients, defects, …) is very important in defining the electromigration resistance of interconnect lines in modern integrated circuits. Recently, techniques have been developed for using submicrometer focused white and monochromatic x-ray beams at synchrotrons to obtain local orientation and strain information within individual grains of thin film materials. In this work, we use the x-ray microdiffraction beam line (7.3.3) at the Advanced Light Source to map the orientation and local stress variations in passivated Al(Cu) test structures (width: 0.7, 4.1 μm) as well as in Al(Cu) blanket films. The temperature effects on microstructure and stress were studied in those same structures by in-situ orientation and stress mapping during a temperature cycle between 25°C and 345°C. Results show large local variations in the different stress components which significantly depart from their average values obtained by more conventional techniques, yet the average stresses in both cases agree well. Possible reasons for these variations will be discussed.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 673: Symposium P – Dislocations and Deformation Mechanisms in Thin Films and Small Structures , 2001 , P7.7
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Chung, J.-S., and Ice, G. E., J. Appl. Physics, 86, 5249–5255 (1999)Google Scholar
[2] Hwang, K.J., Cargill, G.S. III, and Marieb, T., Mat. Res. Soc. Symp. Proc. 612 (2000)Google Scholar
[3] Tamura, N., Valek, B.C., Spolenak, R., MacDowell, A.A., Celestre, R.S., Padmore, H.A., Brown, W. L., Marieb, T., Bravman, J.C., Batterman, B.W., and Patel, J.R., Mat. Res. Soc. Symp. Proc. 612 (2000)Google Scholar
[4] MacDowell, A.A., Celestre, R.S., Tamura, N., Spolenak, R., Valek, B.C., Padmore, H.A., Brown, W. L., Marieb, T., Bravman, J.C., Batterman, B.W., and Patel, J.R., Proceeding of the 7th International Conference on Synchrotron Radiation Instrumentation, in press (2000)Google Scholar
[5] Bain, J.A., Clemens, B.M., MRS Bulletin 17, 46–51 (1992)Google Scholar
[6] Venkatraman, R., Bravman, J.C., Nix, W.D., Davies, P.W., Flinn, P.A., Fraser, D.B., Jour. of Elect. Mat. 19, 1231–1237 (1990)Google Scholar
[7] Hosoda, T., Yagi, H., and Tsuchikawa, H., 1989 International Reliability Physics Symposium Proceedings, IEEE, 202–206 (1989)Google Scholar
[8] , B.Greenbaum, Sauter, A.I., Flinn, P.A., and Nix, W.D., Appl. Phys. Lett. 58, 1845–1847 (1991)Google Scholar
[9] Besser, P.R., Mack, A. Sauter, Fraser, D. and Bravman, J.C., Mat. Res. Soc. Symp. Proc. 309, 287–292 (1993)Google Scholar
[10] Besser, P.R., Stress Induced Phenomena in Metallization, 5th International Workshop, Editors , O.Kraft, , E.Arzt, Volkert, C.A., Ho, P.S., and , H.Okabayashi, 229–239 (1999)Google Scholar
[11] , D.Jawarani, , M.Fernandes, , H.Kawasaki, Ho, P.S., Stress Induced Phenomena in Metallization, 3rd International Workshop, Editors Ho, P.S., , J.Bravman, Li, C.Y., and , J.Sanchez, 32–57 (1995)Google Scholar
[12] Hertzberg, R.W., Deformation and Fracture Mechanics of Materials, 117–118 (1989)Google Scholar
[13] Venkatraman, R. and Bravman, J.C., J. Mater. Res. 7, 2040 (1992)Google Scholar
[14] Thompson, C. V., J. Mater. Res. 8 (2), 237–238 (1993)Google Scholar