Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-03T02:18:13.587Z Has data issue: false hasContentIssue false
  • English
  • Français

The Influence of Heat Treatment upon Fiber Pull-Out in a Ceramic Composite

Published online by Cambridge University Press:  22 February 2011

M. D. Thouless ,
O. Sbaizero ,
E. Bischoff  and
E. Y. Luh
M. D. Thouless
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
O. Sbaizero
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
E. Bischoff
Affiliation:
Materials Department, University of California, Santa Barbara, CA 93106
E. Y. Luh
Affiliation:
Department of Materials Science and Mineral Engineering, University of California, Berkeley, CA 94720.
Get access

Abstract

The toughness of ceramic-matrix composites is strongly influenced by fiber pull-out. The extent of the pull-out depends upon the properties of the fiber and the fiber/matrix interface. Samples of a SiC/LAS composite were subjected to different heat treatments in order to systematically vary these properties. The predicted distribution of the fiber pull-out lengths was calculated by combining a shear lag analysis with Weibull statistics for the fiber strengths. Comparison of the analysis with experiments and microstructural observations contribute to an understanding of the role of the fiber/matrix interface upon the mechanical properties.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 120: Symposium G – High-Temperature/High-Performance Composites , 1988 , 333
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Marshall, D.B. and Evans, A.G., J. Am. Ceram. Soc., 68, (5), 225 (1985).CrossRefGoogle Scholar
2 Brennan, J.J. and Prewo, K.M., J. Mater. Sci., 17, (8) 2371 (1982).CrossRefGoogle Scholar
3 Thouless, M.D. and Evans, A.G., Acta Metall.,(in press).Google Scholar
4 Bischoff, E., Rühle, M., Sbaizero, O. and Evans, A.G. (to be published).Google Scholar
5 Brennan, J.J., Ceramic Microstructures '86: Role of Interfaces., edited by A.G. Evans and J.A. Pask, Plenum, New York.Google Scholar
6 Marshall, D.B., J. Am. Ceram. Soc., 67, (12), C259 (1984).Google Scholar
7 Thouless, M.D., Sbaizero, O. and Evans, A.G. (to be published).Google Scholar
8 Marshall, D.B., Ceramic Microstructures '86: Role of Interfaces., edited by A.G. Evans and J.A. Pask, Plenum, New York.Google Scholar