Article contents
Hydrogen Plasma Treatment of Natural and Homoepitaxial Diamond
Published online by Cambridge University Press: 10 February 2011
Abstract
As-polished and homoepitaxial diamond (100)- and (111)-oriented single crystals, natural diamond powders of 0.12-6 μm diameter, and high-pressure/hightemperature (HPHT) diamond powders of 50-100 μm diameter were treated in a microwave hydrogen plasma under four sets of conditions. Negligible changes in the weights (±10 μg) of the as-polished and homoepitaxial diamonds were observed.Post-treatment atomic force microscopy (AFM) showed a combination of smoothing and pit formation on (100) surfaces, the details of which were sensitive to the structure of the starting surface. Asymmetric pits formed on an as-polished (111) surface, but no qualitative changes in the structure of highly defective (100) and (111) films were observed. Natural diamond powders, which were quite irregular and rough prior to treatment, became markedly smoother and well-faceted, as observed by scanning electron microscopy (SEM). The degree of faceting was sensitive to plasma power level but was independent of H2 flow rate. The size and degree of faceting appeared to be the same after plasma treatment for isolated and closelypacked particles; however, the latter fused into a quasi-continuous film. “Regrown” crystallites were observed on the surfaces of synthetic type Ib diamond particles following plasma treatment. We argue that surface diffusion is the dominant mechanism for the observed morphological changes.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 1996
References
REFERENCES
- 9
- Cited by