Article contents
Hot-Wire Deposited Nanocrystalline Silicon TFTs on Plastic Substrates
Published online by Cambridge University Press: 01 February 2011
Abstract
Hot-wire chemical vapor deposition (HWCVD) technique was used to deposit nanocrystalline silicon (nc-Si) thin film transistors (TFT) on thin polyimide sheets. Two straight tantalum filaments at 1850°C with a substrate to filament distance of 4 cm was used to deposit HWCVD nc-Si with no thermal damage to plastic sheet. Top-gate staggered TFTs were fabricated at 150°C and 250°C using a HWCVD nc-Si channel, PECVD silicon nitride gate dielectric, and microcrystalline n+ drain/source contacts. Leakage current of 3.3×10-12 A, switching current ratio of 3×106, and sub threshold swing of 0.51 V/decade were obtained for TFTs with aspect ratio of 1400 µm / 100 µm fabricated at 150°C. The highest electron field effect mobility was found to be 0.3 cm2/V.s observed for TFTs deposited at lower substrate temperature. Measurements showed superior threshold voltage stability of HW nc-Si TFTs over their amorphous silicon (a-Si) counterparts.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 2007
References
- 2
- Cited by