Hostname: page-component-586b7cd67f-t8hqh Total loading time: 0 Render date: 2024-11-29T07:29:48.668Z Has data issue: false hasContentIssue false

High Resolution X-Ray Characterization of Tl-2212 Superconducting Thin Films

Published online by Cambridge University Press:  21 March 2011

M.J. Daniels
Affiliation:
Center for Nanomaterials Science, Department of Materials Science and Engineering, University of Michigan, Ann Arbor, MI, 48109
J.C. Bilello
Affiliation:
Center for Nanomaterials Science, Department of Materials Science and Engineering, University of Michigan, Ann Arbor, MI, 48109
Z.U. Rek
Affiliation:
Stanford Synchrotron Radiation Laboratory, Menlo Park, CA 94025
D. Hyland
Affiliation:
Department of Engineering Science, University of Oxford, Oxford OX1 3PJ, UK
D. Dew-Hughes
Affiliation:
Department of Engineering Science, University of Oxford, Oxford OX1 3PJ, UK
C.R.M. Grovenor
Affiliation:
Department of Materials, University of Oxford, Oxford OX1 3PH, UK
Get access

Abstract

Thallium based high temperature superconducting films were formed on LaAlO3 (LAO) substrates by thalliation of sputtered amorphous precursor films by reaction with Tl2O. High resolution strain measurements and diffraction topographic imaging studies were performed using the synchrotron at Stanford Synchrotron Radiation Laboratory (SSRL). From these results, we have reached preliminary conclusions regarding the effect of film strain and substrate twinning on the superconducting properties of Tl-2212 films on LAO substrates. High- resolution strain measurements showed a correlation between film strain and microwave properties. The relative strain in samples in which Q>105 at 5.55 GHz (at 50 K) was approximately 30% lower than that in samples in which Q<104 when tested under the same conditions. Examination of samples where Q<104 at 5.55 GHz (at 50 K) by SEM also indicated microstructure defects that are typical in films with a high level of residual stress. White beam x-ray diffraction topographic analysis was used to quantitatively measure the degree of twinning in the substrate. The results will discuss the relationship between the measured Q values of the microwave cavity and the strain state, microstructure and defect morphology in the superconducting film/substrate couple.

Type
Research Article
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Ginley, D.S., Kwak, J.F., Venturini, E.L., Morosin, B., Baughman, R.J., Physica C., 160 42 (1989).Google Scholar
2 Bramley, A.P., O'Connor, J.D. and Grovenor, C.R.M, Supercon. Sci. Technol., 12 R5774 1999.Google Scholar
3 Holstein, W.L. and Parisi, L.A., J. Mater. Res., 11 1349 (1996).Google Scholar
4 Chrzanowski, J., Meng-Burany, S., Xing, W.B., Curzon, A.E., Irwin, J.C., Heinrich, B., Cragg, R.A., Habib, F., Angus, V., Anderson, G., Fife, A.A., Supercond. Sci. Technol., 9 113 (1996).Google Scholar
5 Morley, S.M., Jenkins, A.P., Su, L.Y., Adams, M.J., Dew-Hughes, D., Grovenor, C.R.M., IEEE Trans. Appl. Supercond., 3 1753 (1993).Google Scholar
6 Malandrino, G., Richeson, D.S., Marks, T.J., DeGroot, D.C., Schindler, J.L., and Kannewurf, C.R., Appl. Phys. Lett., 58 182 (1991).Google Scholar
7 Jenkins, A.P., Dew-Hughes, D., Edwards, E.G., Hyland, D. and Edwards, D.J., Insat. Phys. Conf. Ser. No. 167 (2000) IOP publishing, 363.Google Scholar