Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-11-29T07:47:06.418Z Has data issue: false hasContentIssue false

High Quality GaAs on Si by Selective Area Epitaxy

Published online by Cambridge University Press:  28 February 2011

N.H. Karam
Affiliation:
Spire Corporation, Patriots Park, Bedford, MA 01730
V. Haven
Affiliation:
Spire Corporation, Patriots Park, Bedford, MA 01730
S.M. Vernon
Affiliation:
Spire Corporation, Patriots Park, Bedford, MA 01730
N. El-Masry
Affiliation:
North Carolina State University, Raleigh, NC
M. Lingunis
Affiliation:
University of California, Los Angeles, CA
N. Haegel
Affiliation:
University of California, Los Angeles, CA
Get access

Abstract

Selective area Epitaxy (SE) of high quality GaAs on Si films has been achieved using conventional MOCVD and Atomic Layer Epitaxy (ALE) nucleation techniques. Epitaxial GaAs films were deposited inside windows etch patterned in the oxide coated Si wafers. SE was found to eliminate wafer warpage, reduce film cracking and reduce the tensile stresses for islands less than 200 µm/side. Complete stress relief has been achieved in 10 µm/side islands after oxide removal. Defect reduction techniques have been employed resulting in two orders of magnitude reduction in the dislocation density and excellent surface morphologies. This paper addresses the potential of SE, by the above techniques in improving the quality of the GaAs on Si films.

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.For a review see “Heteroepitaxy on Si I & II,” Mater. Res. Soc. (MRS) 67 (1986); 91 (1987).Google Scholar
2.Heteroepitaxy on Silicon Fundamental, Structures, and Devices,” MRS 116 (1988).Google Scholar
3.III-V Heterostructures for Electronic/Photonic Devices,” MRS, 145 (1989).Google Scholar
4. Choi, H.K., Mattia, J., Turner, G., Tsaur, B., IEEE EDL-9, 512 (1988); G. Turner, H.K. Choi, J. Mattia, C. Chen, S. Eglash, and B. Tsaur, ref 2, p. 179.Google Scholar
5. Karam, N.H., Haven, V., Vernon, S., Tran, J. and El-Masry, N., Ref. 3, p. 331.Google Scholar
6. Goodman, C. and Pessa, M.V., J. Appl. Phys. 60, R65 (1986); S.M. Bedair, B. McDermott, Y. Ide, M. Tischler, N.H. Karam, and N. El-Masry, 4th Int. Conf. MOVPE, Japan, May (1988); N.H. Karam, H. Liu, I. Yoshida, and S.M. Bedair, Appl. Phys. Lett. 53, (1988).Google Scholar
7. Fitzgerald, E.A., Kirchner, P., Proano, R., Pettit, G., Woodall, J. and Ast, D., Appl. Phys. 65, 2220 (1989).Google Scholar
8. Akiyama, M., Kawarada, Y., and Kaminishi, K., J. Cryst. Growth 68, 21 (1984).Google Scholar
9. Karam, N.H., Haven, V., Vernon, S., Ramdani, J., El-Masry, N., and Haegel, N., Proc. of the MRS fall meeting, Symp. D, Boston, MA (1989); S.M. Vernon et al., ref 3, p. 349.Google Scholar
10. Yamaguchi, M., Sugo, M. and Itoh, Y., Appl. Phys. Lett. 54, 2568, (1989).Google Scholar
11. Ziel, J.P. Van Der, Chand, N. and Weiner, J., MRS, 145, 317 (1989).Google Scholar
12. Yacobi, B.G., Jagannath, C., Zemon, S., Sheldon, P., Appl. Phys. Lett., 52, 555 (1988); S. Zemon, et al., Sol. State Comm. 58(7), 457 (1986).Google Scholar
13. Lingunis, M., Haegel, N. and Karam, N.H. in preparation.Google Scholar