Hostname: page-component-586b7cd67f-t7czq Total loading time: 0 Render date: 2024-11-29T09:09:32.219Z Has data issue: false hasContentIssue false
  • English
  • Français

Growth Mechanisms During Thin Film Crystallization From the Melt

Published online by Cambridge University Press:  28 February 2011

Loren Pfeiffer ,
A. E Gelman ,
K. A. Jackson  and
K. W West
Loren Pfeiffer
Affiliation:
AT&T Bell Laboratories Murray Hill, New Jersey 07974
A. E Gelman
Affiliation:
Dept. of Statistics, Harvard University, Cambridge, MA 02138
K. A. Jackson
Affiliation:
AT&T Bell Laboratories Murray Hill, New Jersey 07974
K. W West
Affiliation:
AT&T Bell Laboratories Murray Hill, New Jersey 07974
Get access

Abstract

We develop a model that appears to account for the existence of a new mode of crystallization recently discovered during zone-melt-recrystallization (ZMR) of silicon thin films on SiO 2 using a scanned strip heater or lamp. Transition to the new crystallization regime is induced by reducing the temperature of the scanned upper heater strip, thus reducing dT/dy, the thermal gradient along the direction of scan at the silicon solidification front. If dT/dy ≤:4 K/mm, the single crystal films have long non-branched subboundaries with tilt misalignments of 0.1 or less, a lateral separation in excess of 50 µm, and consist of rows of short dislocations threading through the film thickness and terminating at the two SiO2 layers. This is in marked contrast to material ZMR scanned at higher dT/dy which shows conventionally branched 1 to 3 subboundaries that consist of edge dislocations running in the plane of the film often for several hundred microns.

Our model extends the {111} faceted-freezing-front picture we have developed previously to take into account the freezing profile with respect to film thickness, and in particular to such profiles at the intersections of pairs of {111} facets where subboundaries are known to form. We propose that the melt-freezing interface profiles at these interior corner intersections are aligned approximately normal to the scan in the high gradient case, but become tilted towards the plane of the SiO2 cap layer for the low gradient case. This tilting accounts in a natural way for the transition from in-plane to threading dislocations.

Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 74: Symposium A – Beam-Solid Interactions and Transient Processes , 1986 , 543
Copyright
Copyright © Materials Research Society 1987

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Geis, M. W., Smith, H. I., Tsaur, B-Y., Fan, J. C. C., Silversmith, D. J., and Mountain, R. W., J. Electrochem. Soc. 129, 2812–18 (1982).Google Scholar
[2] Baumgart, H. and Phillipp, F., Mat. Res. Soc. Symp. Proc. 35, 593–8 (1985).Google Scholar
[3] Pfeiffer, Loren, West, K. W., Paine, Scott, and Joy, D. C., Mat. Res. Soc. Symp. Proc. 35, 583–592 (1985).Google Scholar
[4] Geis, M. W., Chen, C. K., Smith, H. I., Mountain, R. W. and Doherty, L. C., Mat. Res. Soc. Symp. Proc. 35, 575–583 (1985).Google Scholar
[5] Pfeiffer, Loren, West, K. W., Joy, D. C., Gibson, J. M., and Gelman, A. E., Mat. Res. Soc. Symp. Proc. 53, 29–38 (1986).Google Scholar
[6] Geis, M. W., Chen, C. K., Smith, H. I., Nitishin, P. M., Tsaur, B-Y., and Mountain, R. W., Mat. Res. Soc. Symp. Proc. 53, 39–44 (1986).Google Scholar
[7] Gelman, A. E., Pfeiffer, Loren, Gilmer, G. H., Jackson, K. A., and West, K. W., to be published.Google Scholar
[8] Pfeiffer, Loren, Paine, Scott, Gilmer, G. H., Saarloos, Wim van, and West, K. W., Phys. Rev. Letts. 54, 1944–7 (1985).Google Scholar
[9] Geiss, M. W., Smith, H. I., Silversmith, D. J., Mountain, R. W., and Thompson, C. V., J. Electrochem. Soc. 130, 1178–83 (1983).CrossRefGoogle Scholar
[10] Gilmer, G. H., Mat. Res. Soc. Symp. Proc. 13, 249 (1983).CrossRefGoogle Scholar
[11] Dash, W. C., J. Appl. Phys. 30, 459 (1959), and B. Chalmers, Principlesof Solidification, John Wiley and Sons, Inc., New York, 1964 p. 307.Google Scholar