Hostname: page-component-cd9895bd7-mkpzs Total loading time: 0 Render date: 2024-12-27T02:23:40.656Z Has data issue: false hasContentIssue false
  • English
  • Français

Fracture and Yield of a Porous Composite of Trinitrotoluene and Cyclotrimethylene Trinitramine

Published online by Cambridge University Press:  21 February 2011

Donald A. Wiegand  and
J. Pinto
Donald A. Wiegand
Affiliation:
U.S. Army Armament Research, Development, and Engineering Center, Picatinny Arsenal, NJ 07806-5000
J. Pinto
Affiliation:
U.S. Army Armament Research, Development, and Engineering Center, Picatinny Arsenal, NJ 07806-5000
Get access

Abstract

Composites of trinitrotoluene and cyclotrimethylene trinitramine have been studied in uniaxial compression and in triaxial confined compression. Failure by crack propagation and fracture was observed in all uniaxial studies while failure by yield and plastic flow was found for all triaxial confined compression work. The yield strength is approximately a factor of 2 greater than the uniaxial compressive fracture strength. The relationships between the fracture and yield strengths and Young's modulus indicate that all three decrease with increasing porosity. Based on this porosity interpretation, the compressive strength, the yield strength and Young's Modulus may be increased significantly by reducing the porosity.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 207: Symposium I – Mechanical Properties of Porous and Cellular Materials , 1990 , 77
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Wiegand, D. A., Pinto, J. and Nicolaides, N., J. Energetic Materials, In Press.Google Scholar
2. Pinto, J. and Wiegand, D. A., J. Energetic Materials, In Press.Google Scholar
3. Pinto, J., Nicolaides, S. and Wiegand, D. A., Technical Report ARAED-TR-85004 (1985).Google Scholar
4. Wiegand, D. A. and Pinto, J., To Be Published.Google Scholar
5. For example see: Rice, R. W., in “Treatise on Materials Science and Technology Vol 11, Properties and Microstructure“, Ed. MacCrone, R. K., Acedemic Press, New York (1977).Google Scholar
6. Knudsen, F. P., J. Am. Ceramic Soc., 42, 376 (1959).Google Scholar
7. Wang, J. C., J. Mat. Sci., 19, 801 (1984).Google Scholar
8. M. Joyce, Unpublished Results.Google Scholar
9. For example see: Montagut, E. and Kachanov, M., J. Fracture, 37, R55 (1988).Google Scholar
10. Litewka, A., Engr. Fracture 25, 637, 1986.Google Scholar