No CrossRef data available.
Article contents
Formation and characterization of the CuIn(S,Se)2/buffer layer interface in electrodeposited solar cells
Published online by Cambridge University Press: 01 February 2011
Abstract
This paper presents the influence of the solution chemistry of chemical bath deposition (pH and complexing agents) on the performance of CuIn(S,Se)2 cells after an initial CN treatment. It is shown that it is possible to modify the deposition conditions of the CdS by increasing the pH of the solution and by replacing the complexing agent (ammonia) by citrate ions. Both NH3 based and citrate based process give very homogenous and covering thin films. However, in the case of the citrate based process a decrease of open circuit voltage (Voc) and fill factor (FF) and thus of the cell efficiencies is observed. This points out that the main role of the buffer layer is not only related to the specific properties of the CdS itself but also to the near surface modifications of the CuIn(S,Se)2 caused by the presence of the complexing agent in the bath.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 2005