Hostname: page-component-78c5997874-g7gxr Total loading time: 0 Render date: 2024-11-19T12:39:42.421Z Has data issue: false hasContentIssue false
  • English
  • Français

Epitaxial La0.7(Pb1−xSrx)0.3MnO3 Thin CMR Film Room Temperature Bolometer

Published online by Cambridge University Press:  10 February 2011

A. Lisauskas ,
S.I. Khartsev  and
A.M. Grishin
A. Lisauskas
Affiliation:
Dept. of Condensed Matter Physics, Royal Institute of Technology, S- 100 44 Stockholm, Sweden
S.I. Khartsev
Affiliation:
Dept. of Condensed Matter Physics, Royal Institute of Technology, S- 100 44 Stockholm, Sweden
A.M. Grishin
Affiliation:
Dept. of Condensed Matter Physics, Royal Institute of Technology, S- 100 44 Stockholm, Sweden
Get access

Abstract

Using pulsed laser deposition technique we fabricated films of a continuous series of solid solutions La0.7(Pb1−xSrx)0.3MnO3, which undergo metal-to-insulator phase transition close and above room temperature. The optimal composition for uncooled bolometer applications was found at x = 0.37 with maximum of TCR = 7.4 %K−1@ 295 K. Room temperature bolometer demonstrator has been built and tested. Relatively low excess noise (magnitude γ/n of 3·10−21 cm−3) and high TCR enabled achievement of high signal-to-noise ratio of 8·106 √-Hz/K. The observed frequency dispersion of bolometer response has been ascribed to three relaxation mechanisms of the heat transfer: from film thermistor to substrate, from substrate to thermostat, and heat transfer via leads. For fabricated bolometer heat transfer from substrate to thermostat was found to be the slowest one with a time constant of 0.5 s (correspondent substrate-to-thermostat thermal conductance is G = 3·10−3 W/K). Bolometer performance test yields the responsivity ℜ = 0.6 V/W, detectivity D = 9·106 cm√Hz/W and noise equivalent power NEP of 3·10−8 W/√Hz at 30 Hz frame frequency. Further improvement of bolometer thermal isolation using the micromachining technique is believed to achieve the responsivity about 4·103 V/W and detectivity higher than 109 cm√Hz/W@30 Hz.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 602: Symposium JJ – Magnetoresistive Oxides & Related Materials , 1999 , 349
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Rajeswari, M., Chen, C.H., Goyal, A., Kwon, C., Robson, M.C., Ramesh, R., Venkatesan, T., and Lakeou, S., Appl. Phys. Lett. 68, 3555 (1996).Google Scholar
2. Goyal, A., Rajeswari, M., Shreekala, R., Lofland, S.E., Bhagat, S.M., Boettcher, T., Kwon, C., Ramesh, R., and Venkatesan, T., Appl. Phys. Lett. 71, 2535 (1997).Google Scholar
3. Lisauskas, A., Khartsev, S.I., Grishin, A.M., and Palenskis, V., Mat. Res. Soc. Symp. Proc. 574, 365 (1999).Google Scholar
4. Alers, G.B., Ramirez, A.P., and Jin, S., J. Appl. Phys. 68, 3644 (1996).Google Scholar
5. Arora, S.K., Kumar, Ravi, Kanjilal, D., Bathe, Ravi, Patil, S.I., Ogale, S.B., and Metha, G.K., Solid State Comm. 108, 959 (1998).Google Scholar
6. Richards, P.L., J. Appl. Phys. 76, 1 (1994).Google Scholar
7. Dutta, P., Horn, P.M., Rev. Mod. Phys. 53, 497 (1981).Google Scholar
8. Grishin, A.M., Khartsev, S.I., Johnsson, P., Appl. Phys. Lett. 74, 1115 (1999).Google Scholar
9. Khartsev, S.I., Johnsson, P., Grishin, A.M., J. Appl. Phys. 87, 2394 (2000).Google Scholar
10. Parman, C.E., Israeloff, N.E., and Kakalios, J., Phys. Rev. B 47, 12578 (1993).Google Scholar
11. Gruzdeva, A.P., Zerov, V.Yu., Konovalova, O.P., Kulikov, Yu.V., Malyarov, V.G., Khrebtov, I.A., and Shaganov, I.I., J. Opt. Technol. 64, 1110, (1997).Google Scholar
12. Travers, C.M., Jahanzeb, A., Butler, D.P., and Celik-Butler, Z., I. Microelectromech. Syst. 6, 271 (1997).Google Scholar
13. Wormser, E.M., J. Opt. Soc. Am. 43, 15 (1953).Google Scholar