Hostname: page-component-78c5997874-mlc7c Total loading time: 0 Render date: 2024-11-17T18:20:15.018Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of Pb Excess Content on Microstructure and Electrical Properties of Sol Gel Derived PZT Thin Films

Published online by Cambridge University Press:  10 February 2011

Zhan-jie Wang ,
Ryutaro Maeda  and
Kaoru Kikuchi
Zhan-jie Wang
Affiliation:
Mechanical Engineering Laboratory, Agency of Industrial Science and Technology, Ministry of International Trade and Industry, 1–2 Namiki, Tsukuba, Ibaraki 305–8564, Japan
Ryutaro Maeda
Affiliation:
Mechanical Engineering Laboratory, Agency of Industrial Science and Technology, Ministry of International Trade and Industry, 1–2 Namiki, Tsukuba, Ibaraki 305–8564, Japan
Kaoru Kikuchi
Affiliation:
Mechanical Engineering Laboratory, Agency of Industrial Science and Technology, Ministry of International Trade and Industry, 1–2 Namiki, Tsukuba, Ibaraki 305–8564, Japan
Get access

Abstract

Lead zirconate titanate (PZT) thin films were fabricated by a three-step heat-treatment process which involves the addition of -10, 0 and 10 mol% excess Pb to the starting solution and spin coating onto Pt/Ti/SiO2/Si substrates. Crystalline phases as well as preferred orientations in PZT films were investigated by X-ray diffraction analysis (XRD). The microstructure and composition of the films were studied by scanning electron microscopy (SEM), transmission electron microscopy (TEM) and electron probe microanalysis (EPMA), respectively. The well-crystallized perovskite phase and the (100) preferred orientation were obtained by adding 10% excess Pb to the starting solution. It was found that PZT films to which 10% excess Pb was added had better electric properties. The remanent polarization and the coercive field of this film were 34.8 μC/cm2 and 41.7 kV/cm, while the dielectric constant and loss values measured at 1 kHz were approximately 1600 and 0.04, respectively. Dielectric and ferroelectric properties were correlated to the microstructure of the films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 596: Symposium Y – Ferroelectric Thin Films VIII , 1999 , 229
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Schroth, A., Maeda, R., Akedo, J. and Ichiki, M., Jpn. J. Appl. Phys. 37, p. 5342 (1998).Google Scholar
2. Lee, C., Itoh, T., Maeda, R. and Suga, T., Rev. Sci. Instrum. 68, p. 2091 (1997).Google Scholar
3. Lee, C., Itoh, T., Maeda, R., Ohashi, T. and Suga, T., J. Vac. Sci. Technol. B 4, p. 1559 (1997).Google Scholar
4. Maeda, R., Wang, Z. J., Chu, J., Akedo, J., Ichiki, M. and Yonekubo, S., Jpn. J. Appl. Phys. 37, p. 7116 (1999).Google Scholar
5. Wang, Z. J., Maeda, R. and Kikuchi, K. in Design, Test, and Microfabrication of MEMS and MOEMS, edited by Courtois, B., Crary, S. B., Ehrfeld, W., Fujita, H., Karam, J. M., Markus, K., Proceeding of SPIE, 3680(1999), p.948–955.Google Scholar
6. Jaffe, B., Cook, W. R. and Jaffe, H., Piezoelectric Ceramics, Academic Press, London, 1971, pp.259.Google Scholar
7. Tuttle, B. A., Schwartz, R. W., Doughty, D. H. and Voigt, J. A., Mater. Res. Soc. Symp. Proc. 200 (1993) p. 159.Google Scholar
8. Reaney, I. M., Brooks, K., Klissurska, R., Pawlaczyk, C. and Setter, N., J. Am. Ceram. Soc. 77, p. 1209, (1994).Google Scholar
9. Klee, M., Eusemann, R., Waser, R. and Brand, W., J. Appl. Phys. 72, p. 1566 (1992).Google Scholar
10. Carim, A. H., Tuttle, B. A., Doughty, D. H. and Martinez, S. L., J. Am. Ceram. Soc. 74, p. 1455 (1991).Google Scholar
11. Wang, Z. J., Maeda, R. and Kikuchi, K., submitted to Journal of Materials Science.Google Scholar