Hostname: page-component-cd9895bd7-dk4vv Total loading time: 0 Render date: 2024-12-27T02:17:42.005Z Has data issue: false hasContentIssue false
  • English
  • Français

Development of Ferroelectric Data Storage Test System for High-Density and High-speed Read/Write

Published online by Cambridge University Press:  31 January 2011

Yoshiomi Hiranaga ,
Kenkou Tanaka ,
Tomoya Uda ,
Yuichi Kurihashi ,
Yasuhiro Kimoto ,
Hikari Tochishita ,
Michio Kadota  and
Yasuo Cho
Yoshiomi Hiranaga
Affiliation:
[email protected], Tohoku University, Research Institute of Electrical Communication, Sendai, Japan
Kenkou Tanaka
Affiliation:
[email protected], Tohoku University, Research Institute of Electrical Communication, Sendai, Japan
Tomoya Uda
Affiliation:
[email protected], Tohoku University, Research Institute of Electrical Communication, Sendai, Japan
Yuichi Kurihashi
Affiliation:
[email protected], Tohoku University, Research Institute of Electrical Communication, Sendai, Japan
Yasuhiro Kimoto
Affiliation:
[email protected], Tohoku University, Research Institute of Electrical Communication, Sendai, Japan
Hikari Tochishita
Affiliation:
[email protected], Tohoku University, Research Institute of Electrical Communication, Sendai, Japan
Michio Kadota
Affiliation:
[email protected], Murata Manufacturing Co., Ltd., Yasu, Shiga, Japan
Yasuo Cho
Affiliation:
[email protected], Murata Manufacturing Co., Ltd., Yasu, Shiga, Japan
Get access

Abstract

In this study, we have developed ferroelectric data storage test systems based on scanning nonlinear dielectric microscopy (SNDM) to conduct various experiments concerning read/write capability. Nanodomain formation on ferroelectric recording media was studied using the data storage test system. A nanodomain dot array was successfully written on a single-crystal LiTaO3 recording medium. The diameter of the written dot was as small as 7 nm. Epitaxial-thin-film LiTaO3 recording media were also developed. Nanodomain dots with the diameter of 25 nm were written on the thin-film recording medium. In addition, a non-contact probe-height control technique was adopted to solve the problem of tip abrasion using higher-order nonlinear dielectric response detection method. Finally, a hard-disk-drive (HDD)-type ferroelectric data storage test system was developed for conducting read/write tests under conditions close to those of actual operation. Capabilities of reading at the bit rate of 2 Mbps and writing at the bit rate of 20 Mbps were confirmed using the HDD-type data storage test system.

Keywords

ferroelectricstoragescanning probe microscopy (SPM)
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1199: Symposium F –Multiferroic and Ferroelectric Materials , 2009 , 1199-F10-09
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Knoll, A. et. al., Microelectron. Eng. 83, 1692 (2006).Google Scholar
2 Shin, H., Hong, S., Moon, J. and Jeon, J. U., Ultramicroscopy 91, 103 (2002).Google Scholar
3 Setter, N. et. al., J. Appl. Phys. 100, 051606 (2006).Google Scholar
4 Odagawa, N. and Cho, Y., Jpn. J. Appl. Phys. 45, 7560 (2006).Google Scholar
5 Gruverman, A., Auciello, O., Ramesh, R. and Tokumoto, H., Nanotechnology 8, A38 (1997).Google Scholar
6 Park, H., Jung, J., Min, D.-K., Kim, S., Hong, S. and Shin, H., Appl. Phys. Lett. 84, 1734 (2004).Google Scholar
7 Cho, Y., Jpn. J. Appl. Phys. 46, 4428 (2007).Google Scholar
8 Hirose, R., Ohara, K., and Cho, Y., Nanotechnology 18, 084014 (2007).Google Scholar