Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-20T00:12:53.414Z Has data issue: false hasContentIssue false
  • English
  • Français

Carbon Fiber Reinforced Triazin Resin for Endoprostheses

Published online by Cambridge University Press:  22 February 2011

F. J. Esper ,
J. Harms ,
H. Mittelmeier  and
W. Gohl
F. J. Esper
Affiliation:
Robert Bosch CmbH, Materials Research Department, D-7000, Stuttgart, Federal Republic of Germany
J. Harms
Affiliation:
Rehabilitation Hospital, Department of Orthopaedics and Traumatology, D-7516, Langensteinbach-Karlsbad, Federal Republic of Germany
H. Mittelmeier
Affiliation:
University of Saarland, Orthopaedic Clinic, Homburg, Federal Republic of Germany
W. Gohl
Affiliation:
Robert Bosch CmbH, Materials Research Department, D-7000, Stuttgart, Federal Republic of Germany
Get access

Abstract

Metal alloys, ceramics, and thermoplastics are commonly used as materials for endoprostheses, especially artificial hip joints. Prostheses made of these materials still retain disadvantages which have been responsible for failures in the past. A new material, without the abovementioned disadvantages, has been developed. It is a carbon fiber reinforced thermo set based on the triazin resin. Its principle mechanical properties can be matched with those of bone. The new material (referred to as TCF) has a higher bending and fatigue strength than cast metallic alloys if endless fibers are applied. Its creep rate at 37°C under high load (3000 N), as well as its wear rate against metallic or ceramic wear partners, is negligible. Experiments with animals based on ten years of experience show good osteocompatibility of the TCF. Toxic reactions of the tissue caused by the TCF implants themselves, or by fine wear debris found in membranes of connective tissue (or lymph nodes), were not observed at all. Tissue reacts on large particles of TCF wear debris in the same manner as it does on particulates of the same size of polyethylene. It can be expected that the favorable biomechanical and biological properties of the TCF material will make it a good alternative to other materials already in use for construction of endoprostheses, especially hip joints.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 55: Symposium G – Biomedical Materials , 1985 , 203
Copyright
Copyright © Materials Research Society 1986

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Esper, F.J. and Gohl, W., Sprechsaal, Vol.117, No. 3, 1984.Google Scholar
2. Rydell, N., “Forces Acting on the Femoral Head-Prosthesis,” Acta. Orthop. Scand. Suppl. 88, Vol.37 (1966).Google Scholar
3. Spector, M. et al., J. Biomed. Mater. Res. 12, 665 (1978).Google Scholar
4. Harms, J. and Stockmann, M., “Kohlefaserverst, Triazinharzprothesen,” Biomaterialien und Nahtmaterial, p. 91 (1984).Google Scholar
5. Gohl, W. u.a., BMFT-FB-T 82-036, Institu für Festkörpermechanik, Freiburg, IKFM-Bericht V 15/79, Dez. 1979.Google Scholar
6. Pauwels, F., Atlas zur Biomechanik der Gesunden und Kranken Hüfte, Springer-Verlag Berlin/Heidelberg/New York, 1973.Google Scholar
7. Paul, J. P., “Loading on Normal Hip and Knee Joints and on Joint Replacements,” in Advances in Artificial Hip and Knee Joint Technology, ed. by Schaldach, M. and Hohmann, D., Springer, Berlin/Heidelberg/New York, 1976.Google Scholar
8. Rnhrle, H., Scholten, R., and Sollbach, W., BMFT-FB-T, 79–82.Google Scholar
9. Ehard, H., u.a., Bericht BF-V-63.669-1 des Batelle-Instituts, Frankfurt, Febr. 1981.Google Scholar