Hostname: page-component-78c5997874-lj6df Total loading time: 0 Render date: 2024-11-07T20:18:22.808Z Has data issue: false hasContentIssue false
  • English
  • Français

Reliability and Physics Failure of Stretchable Organic Solar Cells

Published online by Cambridge University Press:  13 January 2016

O. K. Oyewole ,
D. O. Oyewole ,
M. G. Zebaze Kana  and
W. O. Soboyejo
O. K. Oyewole*
Affiliation:
Department of Materials Science and Engineering, Kwara State University, Malete, P.M.B 1530, Ilorin, Kwara State, Nigeria. Department of Theoretical and Applied Physics, African University of Science and Technology, Km 10, Airport Road, Galadimawa, Abuja, Federal Capital Territory, Nigeria.
D. O. Oyewole
Affiliation:
Physics Advanced Laboratory, Sheda Science and Technology Complex, Federal Capital Territory, Abuja, Nigeria.
M. G. Zebaze Kana
Affiliation:
Department of Materials Science and Engineering, Kwara State University, Malete, P.M.B 1530, Ilorin, Kwara State, Nigeria.
W. O. Soboyejo
Affiliation:
Department of Mechanical and Aerospace Engineering, Princeton University, Princeton, USA. Princeton Institute of Science and Technology of Materials, Princeton University Princeton, USA. Department of Materials Science and Engineering, African University of Science and Technology, Km 10, Airport Road, Galadimawa, Abuja, Federal Capital Territory, Nigeria.
*
*(Email: [email protected])
Get access

Abstract

Organic solar (OPV) cells are cheap electronics that can replace the widely used high cost silicon-based electronics for electricity generation. They are cheap because of the easy techniques involved in their fabrication processes and they can be produced to cover a large surface area. However, the current low performance of organic electronics has been traced to failure due to interfacial adhesion problems, material processes, and service conditions. Therefore, transportation of charge carriers across the bulk heterojunction system of OPV cells becomes very difficult in the presence of these flaws. In this paper a combined experimental and computational technique is used to study the reliability and physics failure of stretchable OPV cells. Interfacial adhesion energies in the layered structures of OPV cells are measured and compared with theoretical estimated energies. The limit stresses/strains applied on layered OPV cells during service condition are estimated using critical values of the measured interfacial adhesion. The results obtained are, therefore, explained to improve the design of reliable OPV cells.

Keywords

thin filmadhesionfracture
Type
Articles
Information
MRS Advances , Volume 1 , Issue 1: Biomaterials and Soft Materials , 2016 , pp. 21 - 26
Copyright
Copyright © Materials Research Society 2016 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Lacour, S. P., Jones, J., Wagner, S., Li, T. and Suo, Z., Proceedings of the IEEE 93, 1459 (2005).Google Scholar
Li, T., Suo, Z. G., Lacour, S. P. and Wagner, S., J. Mater. Res. 20, 3274 (2005).Google Scholar
Lacour, S. P., Jones, J., Suo, Z. and Wagner, S., IEEE Electron Device Lett. 25, 179 (2004).Google Scholar
Kim, D-H., Xiao, J., Song, J., Huang, Y. and Rogers, John A., Adv. Mater. 22, 2108 (2010).Google Scholar
Yu, C., O’Brien, K., Zhang, Y-H., Yu, H. and Jiang, H., Appl. Phys. Lett. 96, 041111 (2010).Google Scholar
Bowden, N., Huck, W. T. S., Paul, K. E. and Whitesides, G. M., Appl. Phys. Lett. 75, 2557 (1999).CrossRefGoogle Scholar
Stafford, C. M., Vogt, B. D., Harrison, C., Julthongpiput, D. and Huang, R., Macromolecules 39, 5095 (2006).Google Scholar
Watanabe, M., Shirai, H. and Hirai, T., Journal of Applied Physics 92, 4631 (2002).Google Scholar
Lipomi, D. J., Tee, B. C., Vosgueritchian, M. and Bao, Z., Adv. Mater. 23, 1771 (2011).Google Scholar
Pretzl, M., Schweikart, A., Hanske, C., Chiche, A., Zettl, U., Horn, A., Boker, A. and Fery, A., Langmuir 24, 12748 (2008).Google Scholar
Lam, M. T., Clem, W. C. and Takayama, S., Biomaterials 29, 1705 (2008).CrossRefGoogle Scholar
Tong, T., Babatope, B., Admassie, S., Meng, J., Akwogu, O., Akande, W. and Soboyejo, W. O., Journal of Applied Physics, 106, 083708 (2009).Google Scholar
Akogwu, O., Kwabi, D., Munhutu, A., Tong, T. and Soboyejo, W. O., Journal of Applied Physics 108, 123509 (2010).Google Scholar
Veeco Instruments Inc.: Improving the Accuracy of AFM Measurements, the Thermal Tune Solution , Bruker Corporation, Billerica, MA (2005).Google Scholar
Derjaguin, B.V., Muller, V.M. and Toporov, Y.P., Progress in Surface Science 45, 131 (1994).Google Scholar
Rahbar, N., Wolf, K., Orana, A., Fennimore, R., Zong, Z., Meng, J., Papandreou, G., Maryanoff, C. and Soboyejo, W., Journal of Applied Physics 104, 103533 (2008).Google Scholar
Oyewole, O. K., Yu, D., Du, J., Asare, J., Oyewole, D. O., Anye, V. C., Fashina, A., Zebaze Kana, M. G. and Soboyejo, W. O., Journal of Applied Physics 117, 235501 (2015).Google Scholar
Watanabe, M., Soft Matter 8, 1563 (2012).Google Scholar
Yu, , Oyewole, O. K., Kwabi, D., Tong, T., Anye, V. C., Asare, J., Rwenyagila, E., Fashina, A., Akogwu, O., Du, J. and Soboyejo, W. O., Journal of Applied Physics 116, 074506 (2014).Google Scholar