Hostname: page-component-586b7cd67f-rdxmf Total loading time: 0 Render date: 2024-11-26T07:14:09.812Z Has data issue: false hasContentIssue false
  • English
  • Français

On the reproducibility of spray-coated ZnO thin-film transistors

Published online by Cambridge University Press:  13 April 2020

Guilherme R. Lima ,
João P. Braga Open the ORCID record for João P. Braga [Opens in a new window] ,
Giovani Gozzi  and
Lucas Fugikawa-Santos
Guilherme R. Lima
Affiliation:
Physics Department/IBILCE, – São Paulo State University-UNESP, São José Do Rio Preto, SP 15054-000, Brazil
João P. Braga*
Affiliation:
Physics Department/IBILCE, – São Paulo State University-UNESP, São José Do Rio Preto, SP 15054-000, Brazil
Giovani Gozzi
Affiliation:
Physics Department/IGCE, – São Paulo State University-UNESP, Av. 24A, 1515, Rio Claro, SP 13506-900, Brazil
Lucas Fugikawa-Santos
Affiliation:
Physics Department/IGCE, – São Paulo State University-UNESP, Av. 24A, 1515, Rio Claro, SP 13506-900, Brazil
*
*(Email: [email protected])
Get access

Abstract

Recent studies have shown spray-pyrolysis is a low-cost, simple and efficient technique for deposition of metal oxide semiconductors (such as zinc oxide) as the active layer of thin-film transistors (TFTs). However, to allow the translation from laboratory scale to industry the reproducibility of such method needs to be evaluated. We present herein a representative study concerning the reproducibility and uniformity of spray-coated ZnO TFTs using several devices, from different production batches, following the same fabrication protocol. We demonstrate that it is possible to obtain transistors with high performance and reproducibility by controlling the most relevant deposition factors, corroborated by a low deviation rate (below 10%) from the characteristic TFT parameters (mobility in saturation, threshold voltage and on/off ratio), which is compatible to commonly available commercial electronic devices.

Keywords

thin filmspray pyrolysissolution depositionsemiconducting
Type
Articles
Information
MRS Advances , Volume 5 , Issue 35-36: Electronic, Photonic and Magnetic Materials , 2020 , pp. 1859 - 1866
Check for updates
Copyright
Copyright © Materials Research Society 2020

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Fortunato, E., Barquinha, P., and Martins, R., “Oxide semiconductor thin-film transistors: A review of recent advances,” Adv. Mater., vol. 24, no. 22, pp. 2945–2986, 2012.CrossRefGoogle ScholarPubMed
Lin, Z.et al., “High-mobility thin film transistors with neodymium-substituted indium oxide active layer,” Appl. Phys. Lett., vol. 107, no. 11, 2015.CrossRefGoogle Scholar
Isakov, I.et al., “Exploring the Leidenfrost Effect for the Deposition of High-Quality In2O3 Layers via Spray Pyrolysis at Low Temperatures and Their Application in High Electron Mobility Transistors,” Adv. Funct. Mater., vol. 27, no. 22, pp. 1–9, 2017.CrossRefGoogle Scholar
Kolodziejczak-Radzimska, A. and Jesionowski, T., “Zinc oxide-from synthesis to application: A review,” Materials (Basel)., vol. 7, no. 4, pp. 2833–2881, 2014.CrossRefGoogle ScholarPubMed
Bashir, A.et al., “High-performance zinc oxide transistors and circuits fabricated by spray pyrolysis in ambient atmosphere,” Adv. Mater., vol. 21, no. 21, pp. 2226–2231, 2009.CrossRefGoogle Scholar
Pal, B. N., Trottman, P., Sun, J., and Katz, H. E., “Solution-deposited zinc oxide and zinc oxide/pentacene bilayer transistors: High mobility n-channel, ambipolar, and nonvolatile devices,” Adv. Funct. Mater., vol. 18, no. 12, pp. 1832–1839, 2008.CrossRefGoogle Scholar
Afifi, H., Abdel-Naby, M., El-Hefnawie, S., Eliewa, A., and Ahmad, N., “Optical and electrical properties of Zinc Oxide films prepared by spray pyrolysis,” WSEAS Trans. Electron., vol. 2, no. 4, pp. 180–184, 2005.Google Scholar
Wu, P., Zhang, J., Lu, J., Li, X., Wu, C., and Sun, R., “Instability induced by ultraviolet light in ZnO thin-film transistors,” on Electron Devices, vol. 61, no. 5, pp. 1431–1435, 2014.Google Scholar
Acosta Osorno, M. A.et al., “Characterization of ZnO thin films obtained by ultrasonic spray pyrolysis for application in UV photoconductive detectors,” Mater. Res. Express, 2019.CrossRefGoogle Scholar
Braga, J. P., Moises, L. A., Gozzi, G., and Fugikawa-Santos, L., “Prediction of the electrical response of solution-processed thin-film transistors using multifactorial analysis,” J. Mater. Sci. Mater. Electron., vol. 30, no. 18, pp. 16939–16948, 2019.CrossRefGoogle Scholar
Nandhini, M. et al. , “Biofabricated zinc oxide nanoparticles as an eco-friendly alternative for growth promotion and management of downy mildew of pearl millet,” Crop Prot., vol. 121, no. March, pp. 103–112, 2019.Google Scholar
Napi, M. L. M., Sultan, S. M., Ismail, R., How, K. W., and Ahmad, M. K., “Electrochemical-based biosensors on different zinc oxide nanostructures: A review,” Materials (Basel)., vol. 12, no. 18, pp. 1–34, 2019.CrossRefGoogle ScholarPubMed
Ahmad, R., Tripathy, N., Jung, D. U. J., and Hahn, Y. B., “Highly sensitive hydrazine chemical sensor based on ZnO nanorods field-effect transistor,” Chem. Commun., vol. 50, no. 15, pp. 1890–1893, 2014.CrossRefGoogle ScholarPubMed
Gomes, T. C., Kumar, D., Fugikawa-Santos, L., Alves, N., and Kettle, J., “Optimization of the Anodization Processing for Aluminum Oxide Gate Dielectrics in ZnO Thin Film Transistors by Multivariate Analysis,” ACS Comb. Sci., vol. 21, no. 5, pp. 370–379, 2019.CrossRefGoogle ScholarPubMed
Kaushal, A. and Kaur, D., “Pulsed laser deposition of transparent ZnO/MgO multilayers,” J. Alloys Compd., vol. 509, no. 2, pp. 200–205, 2011.CrossRefGoogle Scholar
Malm, J., Sahramo, E., Perälä, J., Sajavaara, T., and Karppinen, M., “Low-temperature atomic layer deposition of ZnO thin films: Control of crystallinity and orientation,” Thin Solid Films, vol. 519, no. 16, pp. 5319–5322, 2011.CrossRefGoogle Scholar
De Lima, G., Braga, JP., Gozzi, G., & Santos, L. (2018). Optimization of the Electrical Performance of Metal Oxide Thin-film Transistors by varying Spray Deposition Parameters. MRS Advances , 3(5), 247-253. doi:10.1557/adv.2018.35CrossRefGoogle Scholar
Ortel, Marlis, Balster, Torsten, and Wagner, Veit; Chemical composition and temperature dependent performance of ZnO-thin film transistors deposited by pulsed and continuous spray pyrolysis. J. Appl. Phys., 114, 234502, 2013.CrossRefGoogle Scholar
George, Adamopoulos, Bashir, Aneeqa, Wöbkenberg, Paul H., Bradley, Donal D. C., and Anthopoulosa, Thomas D.; Electronic properties of ZnO field-effect transistors fabricated by spray pyrolysis in ambient air. Appl. Phys. Lett., 95, 133507, 2009.Google Scholar
Azarova, Natalia A., Jack, W. Owen, Claire A. McLellan, Grimminger, Marsha A., Eric, K. Chapman, John E. Anthony, Jurchescu, Oana D.; Fabrication of organic thin-film transistors by spray-deposition for low-cost, large-area electronics. N.A. Azarova et al. / Organic Electronics, 11, 1960–1965, 2010.Google Scholar
Wagner, C. D., Gale, L. H., and Raymond, R. H., “Two-Dimensional Chemical State Plots: a Standardized Data Set for Use in Identifying Chemical States By X-Ray Photoelectron Spectroscopy.,” Anal Chem, vol. 51, no. 4, pp. 466–482, 1979.CrossRefGoogle Scholar
Al-Gaashani, R., Radiman, S., Daud, A. R., Tabet, N., and Al-Douri, Y., “XPS and optical studies of different morphologies of ZnO nanostructures prepared by microwave methods,” Ceram. Int., vol. 39, no. 3, pp. 2283–2292, 2013.CrossRefGoogle Scholar